McIntosh MC205 owner manual Specifications

Page 18

Specifications

Specifications

Power Output

Minimum sine wave continuous average power output per channel, all channels operating is:

200 watts into a 4 ohm or 8 ohm load

Output Load Impedance 8 and 4 ohms

Rated Power Band

20Hz to 20,000Hz

Total Harmonic Distortion

0.005% maximum harmonic distortion at any power level from 250 milliwatts to rated power, 20Hz to 20,000Hz

Dynamic Headroom 1.7dB

Frequency Response

+0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz

Input Sensitivity (for rated output)

2.0Volt Balanced with a 4 ohm Loudspeaker

1.0Volt Unbalanced with a 4 ohm Loudspeaker

2.8Volt Balanced with a 8 ohm Loudspeaker

1.4Volt Unbalanced with a 8 ohm Loudspeaker

Signal To Noise Ratio (A-Weighted)

112dB below rated output

Intermodulation Distortion

0.005% maximum, if the instantaneous peak power output is rated power or less per channel with all channels op- erating for any combination of frequencies from 20Hz to 20,000Hz.

Wide Band Damping Factor

Greater than 70 at 4 ohms

Greater than 140 at 8 ohms

Input Impedance

20,000 ohms Balanced

10,000 ohms Unbalanced

Power Guard

Less than 2% THD with up to 14dB overdrive at 1,000Hz

Power Requirements

100 Volts, 50/60Hz at 12 Amps

110 Volts, 50/60Hz at 11 Amps

120 Volts, 50/60Hz at 10 Amps

220 Volts, 50/60Hz at 6 Amps

230 Volts, 50/60Hz at 6 Amps

240 Volts, 50/60Hz at 6 Amps

Note: Refer to the rear panel of the MC205 for the correct voltage.

Overall Dimensions

Width is 17-1/2 inches (44.45cm)

Height is 9-7/16 inches (23.97cm) including feet

Depth is 21 inches (53.3cm) including the Front Panel and Cables

Weight

81 pounds (44.2 kg) net, 114 pounds (51.8 kg) in shipping carton

Shipping Carton Dimensions

Width is 29-1/2 inches (74.93cm)

Depth is 30-1/2 inches (77.47cm)

Height is 17-1/2 inches (44.45cm)

18

Image 18
Contents Power Amplifier Important Safety Instructions Thank You Customer ServiceTable of Contents Please Take a MomentPerformance Features IntroductionDimensions Front View of the MC205 Rear View of the MC205Installation Rear Panel Connections How to Connect for a Five Channel System MC205 Power Control ZAHow to Connect for a Five Channel System How to Connect for a Seven Channel System How to Connect for a Seven Channel System How to Connect for a Five Channel and Zone B System How to Connect for a Five Channel and Zone B System Front Panel Displays and Switches Impedance Switch How to Operate the MC205Power Power Output MetersTechnical Description Design PhilosophyProtection Circuits Power Supply Circuits Specifications Packing Instructions McIntosh Laboratory, Inc Chambers Street Binghamton, NY