Operation
Safety Interlock Switches | Stopping the Engine |
5
This tractor is equipped with a safety interlock system for the protection of the operator. If the interlock system should ever malfunction, do not operate the tractor. Contact your authorized service dealer.
•The safety interlock system prevents the engine from cranking or starting unless the parking brake is engaged, and the PTO (Blade Engage) lever is in the disengaged (OFF) position.
•The engine will automatically shut off if the operator leaves the seat before engaging the parking brake.
Warning! Do not operate the tractor if the interlock system is malfunctioning. This system was designed for your safety and protection.
Starting the Engine
NOTE: Refer to the Assembly &
1.Insert the tractor key into the ignition switch module.
2.Place the PTO (Blade Engage) lever in the disengaged (OFF) position.
3.Engage the tractor’s parking brake.
4.Activate the choke control by moving the throttle/choke control all the way forward into the choke position.
5.Turn the ignition key clockwise to the START position. After the engine starts, release the key. It will return to the
NORMAL MOWING position.
Caution: Do NOT hold the key in the START position for longer than ten seconds at a time. Doing so may cause damage to your engine’s electric starter.
6.After the engine starts, deactivate the choke control.
NOTE: Do NOT leave the choke control on while operating the tractor. Doing so will result in a “rich” fuel mixture and cause the engine to run poorly.
Warning! If you strike a foreign object, stop the engine and disconnect the spark plug wire(s). Thoroughly inspect the machine for any damage. Repair the damage before restarting and operating.
1.If the blades are engaged, place the PTO/Blade Engage lever in the disengaged (OFF) position.
2.Place the throttle control near the SLOW position.
3.Turn the ignition key counterclockwise to the STOP position.
4.Remove the key from the ignition switch to prevent unintended starting.
15