MTD 1742 warranty Adjustments, Deck Spindle, Leveling the Deck Front To Rear

Deck Spindle

Grease fittings can be found on each deck spindle. See Fig. 6-4. Lubricate with 251H EP grease or an equivalent No. 2 multi- purpose lithium grease. Using a grease gun, apply two strokes (minimum) or sufficient grease to the spindle shaft.

Figure 6-4

Adjustments

WARNING! Shut the engine off, remove the ignition key and engage the parking brake before making adjustments. Protect your hands by using

heavy gloves when handling the blades.

NOTE: Check the tractor’s tire pressure before performing any deck leveling adjustments. Refer to Tires on page 28 for information regarding tire pressure.

Leveling the Deck (Front To Rear)

The front of the cutting deck is supported by a stabilizer bar that can be adjusted to level the deck from front to rear. The front of the deck should be between 1⁄4-inch and 3⁄8-inch lower than the rear of the deck. Adjust if necessary as follows:

1.Park the tractor on a firm, level surface and place the deck lift lever in the middle position.

2.Rotate the blade nearest the discharge chute so that it is parallel with the tractor.

3.Measure the distance from the front of the blade tip to the ground and the rear of the blade tip to the ground. The first measurement taken should be between 1⁄4” and 3⁄8” less than the second measurement.

Determine the approximate distance necessary for proper adjustment and proceed, if necessary.

1.To raise the front of the deck, tighten (thread inward) the hex lock nut against the front hanger bracket. See Fig. 6-5.

Figure 6-5

2.To lower the front of the deck, loosen (thread outward) the hex lock nut, away from the front hanger bracket.

See Fig. 6-5.

22

Section 6 — Maintenance & Adjustments