M&S Systems Speaker manual Samb Mount- ing Bracket For Existing Construction

Page 4

EXISTING CONSTRUCTION

STEP 1 After you have determined the location of the speaker, attach the mounting flanges to the mounting ring as shown in Figure 2. Install the mounting ring in the wall and position it so that the extending flanges are behind the drywall material. Bend the front flanges over the dry wall as shown in Figure 2.

Figure 2 - SAMB Mount- ing Bracket For Existing Construction

Wall stud

mounting ring

drywall screws

flange mounting screws

flange

Bend

Tabs as

Shown

STEP 2 Run a 16 gauge 4-conductor cable, such as MS164X, from the volume control to the SUM. Then run one 2- conductor cable such as MS16X, to each left and right channel speaker. (See Figure 3.) A 16 gauge 4- conductor cable should also be run from the volume control to the system amplifier. Be sure that you se- cure the wire (DO NOT USE STAPLES) and leave enough wire for the speaker connections. Connect the wires to the SUM and speakers.

Page 4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Passive IN-WALL Subwoofer & Mounting Bracket Impor tant Safety I nstructio ns Introd uctionTools R eq ui red Installatio n Instruction sNEW Construction Existing Construction Samb Mount- ing Bracket For Existing ConstructionTypical SUM Installation Ser vi ce and Tro ubl eshooting Warranty Systems Limited 2-Year No-Fault Product WarrantyPhone
Top Page Image Contents