MTD 18HP service manual General Safety Operations, Safety Precautions

Page 4

GENERAL SAFETY

OPERATIONS

A.DANGER

1.Do not operate machine in confined areas where exhaust gases can accumulate.

2.Do not operate machine without mower chute deflector in place and operational.

3.Do not carry passengers.

B.WARNING

1.Do not operate machines under the influence of alcohol or drugs.

2.Do not operate machines without all guards and safety devices in place and functional.

3.Do not start machines if there are fuel or oil leaks or spillage — clean it up.

4.Do not operate machines near spilled or leak- ing fuels.

5.Do not stop or park machine over dry leaves, grass, debris, etc. that could be combustible.

6.Use extreme care when backing up.

7.Do not operate machine on slopes greater than 15 degrees (27%).

8.Do not operate machines on slopes when traction is reduced (wet grass, ice, soft ground, loose ground, leaves, pine needles, debris, etc.).

9.Avoid turning downhill if possible, go slowly and use extra care when turning downhill.

10.Do not operate machines during reduce visi- bility (low light, fog, rain, etc.).

11.Do not operate machines with non-approved attachments.

12.Do not operate machines that are dam- aged.....have machine repaired.

13.Do not operate machines that have not been properly maintained.

14.Use only replacement parts that are the same or equivalent to the original equipment.

15.Do not modify machines or any of their com- ponents, especially the engine governor!

16.Do not operate machine for more than 2 hours without hearing protection.

C.CAUTION

1.Use proper protective equipment when oper- ating machine (gloves, boots, and hearing protection are recommended).

2.Read entire machine Operator’s Manual.

3.Make sure operators are fully trained in the safe use of the machine.

4.Follow all safety instructions when using the machine.

5.Keep all safety signs legible and properly installed.

6.Do not check for hydraulic leaks with any part of the body.

7.Do not add fuel to a machine when the engine is running and/or the exhaust system is hot.

8.Keep machine clean and free of debris, grass, leaves, oil, grease, etc.

9.Place lap bars in neutral/start position, set park brake, disengage P.T.O., turn engine off, and remove ignition key before you dismount from machine.

10.Use machines laterally or diagonally across slopes, avoid going downhill when possible.

11.Go slowly and use extra care when descend- ing slopes.

12.Disengage P.T.O. when crossing surfaces such as asphalt, concrete, loose ground, sand, gravel, etc.

13.Use extra care when loading and unloading machines from trucks or trailers.

SAFETY PRECAUTIONS

A.General

1.Read this Operator’s Manual before starting the mower. Study the controls and learn the proper sequence of operation.

2.Do not allow anyone to operate or maintain this machine who has not read this manual. Never permit children to operate this machine.

3.Never carry passengers.

4.Do not remove any shields, guards or safety devices. If a shield, guard or safety device is damaged or does not function, repair or replace it before operating the mower.

5.Always wear safety glasses and safety shoes when operating or maintaining this mower. Do not wear loose-fitting clothing.

6.Disconnect the spark plug wires and remove the key from the ignition to prevent the engine from accidentally starting before performing any maintenance on this mower.

7.Never run the engine indoors without ade- quate ventilation. Exhaust fumes are deadly.

8.To avoid serious burns, do not touch the engine, exhaust pipe or muffler while the engine is running or until it has cooled after it has been shut off.

9.The liquid in the battery is dilute sulfuric acid. Always wear safety glasses and rubber gloves when working on the battery. Do not overfill the battery.

10.Lead-acid batteries generate hydrogen and oxygen gases which form an explosive mix- ture. Keep sparks and flames away at all times.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents MMZ Jr Hydrostatic Zero-Turn Riding Mower Table of Contents Forward Safety Precautions General Safety OperationsGeneral When Mowing Related to FuelSafety Decals and Labels Shield Missing do not OperateSpecifications Safety Awareness when Mowing When MowingOperating Instructions To Mow Grass and Produce a Striped Pat- tern Figure Fuel Shutoff Valve Initial Adjustments Check the fluid levels and tiresZero Turn Break-In And Operating Procedures Lubricate all fittings listed in the mainte- nance sectionOrientation Initial OperationStart the Engine Maintenance Service Mower DeckParking the Mower Removing the Mower DeckChanging a Blade Changing the Blade Drive BeltsChanging the Spindle Assembly Stop the engine and remove the key from the ignition switchHydraulic Oil Adding Hydraulic Oil use SAE20WBattery Removal Installing the BatteryElectrical Circuit Specific Gravity Freezing Temp FPage Brakes TiresInflation Pressure Hydraulic System Hydraulic Oil Tank and FilterStorage Maintenance Schedule OIL Chart If Mower is so equippedHigh Speed Tracking Adjustment Enginge RPM Check and AdjustmentDeck Corner Ball Wheel Roller Settings Deck Center Anti-Scalp Roller SettingsLap Bar Adjustment Deck leveling ProcedureHeight of Cut LInk Point a Jam Nuts Point C Wiring Diagram Equipment TWO-YEAR Limited Warranty

18HP specifications

The MTD 18HP is a robust and reliable lawn tractor that has gained popularity amongst gardening enthusiasts and homeowners alike. This machine is designed to provide efficient performance while maintaining a user-friendly experience. One of the standout features of the MTD 18HP is its powerful 18 horsepower engine, which ensures that users can tackle even the toughest mowing tasks with ease. The engine is engineered to deliver impressive torque, making it suitable for a variety of environments and terrain types.

One of the key technologies integrated into the MTD 18HP is its hydrostatic transmission system. This feature allows for smooth and seamless operation, enabling the operator to effortlessly control the speed and direction of the mower without the need for shifting gears. This element greatly enhances the overall user experience and makes the machine easier to handle, especially for those who may be new to operating tractors.

The cutting deck of the MTD 18HP is another remarkable attribute. Typically featuring a 42-inch or 46-inch cutting width, the deck is designed for efficient grass cutting and allows for quick maneuverability around obstacles. With multiple cutting height adjustments, users can customize their mowing height to suit their lawn's specific needs. The durable construction of the cutting deck also aids in extending the lifespan of the mower while ensuring that it can withstand challenging mowing conditions.

Additionally, the MTD 18HP is equipped with ergonomic controls that enhance comfort during operation. The contoured seat and easy-to-reach controls promote a more enjoyable mowing experience, reducing fatigue during extended usage. The tractor also features large rear wheels that provide excellent traction and stability on uneven terrain.

Safety is a priority with the MTD 18HP, which includes features such as an automatic blade brake that engages when the operator leaves the seat, preventing any accidental injury.

In summary, the MTD 18HP is a powerful, user-friendly lawn tractor that combines impressive engine performance with innovative technologies and thoughtful design features. From its hydrostatic transmission to its adjustable cutting deck and ergonomic controls, this tractor is well-equipped to handle a range of yard maintenance tasks with ease and efficiency. Whether for residential or light commercial use, the MTD 18HP remains a solid choice for those who seek reliability and performance in their lawn care equipment.
Top Page Image Contents