MTD 500 thru 510 manual Important Safe Operation Practices, Training

Page 3

SECTION 1: IMPORTANT SAFE OPERATION PRACTICES

WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol - heed its warning.

WARNING: Engine Exhaust, some of its constituents, and certain vehicle

components contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

TRAINING

1.Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts.

2.Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly.

3.Never allow children under 14 years old to operate this machine. Children 14 years old and over should read and understand the operation instructions and safety rules in this manual and should be trained and supervised by a parent.

4.Never allow adults to operate this machine without proper instruction.

5.Many accidents occur when more than one person operates the machine. If a helper is assisting in loading logs, never activate the control until the helper is a minimum of 10 feet from the machine.

6.Keep bystanders, helpers, pets, and children at least 20 feet from the machine while it is in operation.

7.Never allow anyone to ride on this machine.

8.Never transport cargo on this machine.

9.Hydraulic log splitters develop high fluid pressures during operation. Fluid escaping through a pin hole opening can penetrate your skin and cause blood poisoning, gangrene, or death. Give attention to the following instructions at all times:

a.Do not check for leaks with your hand.

b.Do not operate machine with frayed, kinked, cracked, or damaged hoses, fitting, or tubing.

c.Stop the engine and relieve hydraulic system pressure before changing or adjusting fittings, hoses, tubing, or other system components.

d.Do not adjust the pressure settings of the pump or valve.

10.Leaks can be detected by passing cardboard or wood, while wearing protective gloves and safety glasses, over the suspected area. Look for discoloration of cardboard or wood.

11.If injured by escaping fluid, see a doctor immediately. Serious infection or reaction can develop if proper medical treatment is not administered immediately.

12.Keep the operator zone and adjacent area clear for safe, secure footing.

13.If your machine is equipped with an internal combustion engine and it is intended for use near any unimproved forest, brush, or grass covered land, the engine exhaust should be equipped with a spark arrester. Make sure you comply with applicable local, state, and federal codes. Take appropriate firefighting equipment with you.

14.This machine should be used for splitting wood only, do not use it for any other purpose.

15.Follow the instructions in the manual(s) provided with any attachment(s) for this machine.

PREPARATION

1.Always wear safety shoes or heavy boots.

2.Always wear safety glasses or safety goggles during operating this machine.

3.Never wear jewelry or loose clothing that might become entangled in moving or rotating parts of the machine.

4.Make sure this machine is on level surface before operating.

5.Always block the machine as required to prevent unintended movement, and lock in either the horizontal or vertical position.

6.Always operate this machine from the operator zone(s) specified in the manual.

7.Logs should be cut with square ends prior to splitting.

8.Use your log splitter in daylight or under good artificial light.

3

Image 3
Contents OPERATOR’S Manual Table of Contents Training Important Safe Operation PracticesOperation Assembling The Tongue Assembling Your LOG SplitterRemoving Unit From Crate Loose Parts In CartonConnecting the Cylinder to Beam Preparing The Log SplitterAttaching The Tongue See Figure Engine Controls Know Your LOG SplitterControl Handle Beam LocksEngines with choke lever Operating Your LOG SplitterGas And Oil Fill-Up Starting EngineUsing The Log Splitter Maintaining Your LOG Splitter Adjusting Your LOG SplitterWedge Assembly Adjustment Gib AdjustmentEngine Hydraulic FilterBeam And Splitting Wedge Hose ClampsStoring Your Log Splitter Conditions That will Void WarrantyProblem Cause Remedy TroubleshootingHydraulic Troubleshooting Page Model Series 500 thru Part Description Page Page MANUFACTURER’S Limited Warranty