Assembly Instructions:
A.Hose Assembly (Figure #1)
1.Remove the Hose from the box.
2.With the assistance of a second person, hold the hose at both ends and stretch it out as far as possible. This will maximize the hose length and open the internal diameter.
3.Insert the Hose Flange Assembly into one of the open ends as shown.
4.Using one of the Hose Clamps, secure the hose to the Hose Flange Assembly by wrapping the clamp around the hose portion covering the Hose Flange and tighten.
HOSE
INTAKE NOZZLE
HANDLE
5.Insert the Intake Nozzle into the end of the hose opposite the hose flange as shown.
6.Using the second Hose Clamp, secure the hose to the Intake Nozzle by wrapping the clamp around the hose portion covering the Intake Nozzle and tighten.
7.Install the Intake Nozzle Handle as shown.
8.To secure the Intake Nozzle Handle to the Intake Nozzle, insert the (4) Bolts (720597) and (4) Nuts (720583) that have been provided for the installation.
HOSE FLANGE
ASSEMBLY
HOSE CLAMP
Figure #1
INTAKE NOZZLE | HOSE CLAMP |
BOLT
NUT
B. Mounting the Shredding TruckLoader Frame (Figure #2)
LIFTING LUG
1. There are four holes in the TruckLoader frame deck through which the unit can be secured to an appropriate mounting surface. For your convenience,
(4) Bolts (720599) and (4) Nuts (720560) have been provided for the installation.
2. For the purpose of lifting your unit, two options have been provided for you. The first option is a lifting lug found near the engine muffler mounted on the backside of the Housing Assembly. This lug has been designed to hold a maximum of 500 pounds. The second option is the lifting bars, which are incorporated in the frame and found on either side of the Housing Assembly.
FRAME DECK MOUNTING HOLES
FRAME LIFTING BARS
Figure #2
5