Door Catch Ball Assembly Independent Doors

FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS

NOTE: The door assembly is heavy and will drop down once the last screw is removed. If removing door assembly with-out assistance, the ignition cable, flame sense lead and gas manifold should also be removed to avoid damage to these components.

5.Lift up on the door assembly and swing the right side out then move the assembly to the left to clear the slots in the upper door sill.

6.Lay the door assembly on a flat cushioned surface for disassembly.

7.Reverse procedure to install door assembly and check for proper adjustment as outlined under

DOOR ADJUSTMENT, DOOR CHAIN ADJUSTMENT (SIMULTANEOUS DOORS) and DOOR SWITCH ADJUSTMENT in SERVICE PROCEDURES AND ADJUSTMENTS.

Disassembly

1.Remove the door assembly as outlined in OVEN DOORS (SIMULTANEOUS) under ASSEMBLY REMOVAL.

2.Remove the door chain by loosening one of the turnbuckles.

3.Loosen the set screw on the sprocket of door being replaced.

4.Drive out the spiral pin from the sprocket of door being replaced.

5.Remove the door from lower sill bearings and sprocket.

A. Door assembly parts are now accessible for inspection and/or replacement if necessary.

6.Reverse procedure to re-assemble the door assembly parts and check for proper adjustment as outlined under DOOR CHAIN ADJUSTMENT (SIMULTANEOUS DOORS) in SERVICE PROCEDURES AND ADJUSTMENTS.

DOOR CATCH BALL ASSEMBLY

(INDEPENDENT DOORS)

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

1.Remove the top front cover as outlined under

COVERS AND PANELS.

2.Remove the screws that secure the door catch assembly.

3.Reverse procedure to install.

4.Adjust the ball catch as outlined under DOOR CATCH BALL ADJUSTMENT (INDEPENDENT DOORS) in SERVICE PROCEDURES AND ADJUSTMENTS.

DOOR WINDOW