Covers and Panels, Top Front Cover, Control Panel

FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS

COVERS AND PANELS

WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.

1.The top front cover is secured with four (4) screws, two on each side of cover. Remove these screws then remove the cover from the oven.

2.Reverse the procedure to install.

1.The bottom front cover is secured with four (4) screws, two on each side of cover. Remove these screws then remove the cover from the oven.

2.Reverse the procedure to install.

1.Remove three (3) screws on the right side which secure the control panel then pull the panel away from the oven.

NOTE: If the oven has a mechanical (KX type) thermostat, it must be removed from the control panel first, before removing the control panel.

2.Disconnect the temperature probe leads from the solid state temperature control.

3.Unplug the wire harness connector to the control panel components.

4.Reverse the procedure to install.

1.Remove the screws which secure the right side of the top front cover, bottom front cover and control panel.

2.Remove the remaining six screws securing the right side panel.

3.Pull the right side panel out at the bottom then down to remove.

4.Reverse the procedure to install.

Page 5 of 64		F32700 (February 2006)