Little Wonder 2/1/1960, 91270-03-01 owner manual SET-UP Instructions

LITTLE

WONDER BLOWER

SET-UP INSTRUCTIONS

SET-UP INSTRUCTIONS

1.	Open box. Remove upper handle and cardboard
	insert.
2.	Lay box down with blower housing up. Use lower
	handle to roll unit out of the box.
3.	Locate hardware package.
4.	Install upper handle to lower handle with (4) 3/8-16
	x 1-3/4 carriage bolts and (4) 3/8-16 flanged nylon
	insert nuts from the hardware package. Tighten the
	nuts securely but not so much as to crush the tube.
	(Figure 1)
5.	If equipped with a Throttle Cable: Route the
	throttle cable in front of lower handle crossbar.	FIGURE 2
	Install to the left side of the upper handle with (2)
	10-32 x ½ thread forming screws from the hardware
	package. (Figure 2)
6.	If equipped with a Throttle Cable: Secure the
	throttle cables to the handle tubes with cable ties
	from the hardware package. Trim off excess.
	(Figure 3)
7.	Fill the engine with oil to the level indicated on the
	dipstick. Fill the fuel tank with clean, fresh regular
	grade unleaded gasoline.

FIGURE 3

FIGURE 1

9