Lewmar Issue 2 warranty Previous Page Page 2

Page 32

User Notes

Concept circular hatches are restricted to 85 degree opening and should not be forced beyond their "stop" position, as damage to the lever mechanism may occur.

The ventilation position is used by closing the handles into the rebate in the lower frame. Care should be taken not to stand on or load the hatch lid in this position, as damage could occur to the handle or window assembly.

The hatch must always be closed when the boat is in motion to prevent accidental damage.

Where used, the flyscreen is fitted by using the sewn on tabs to stretch it across to the poppers on the trim frame. Ensure that the elasticated bead is correctly located into the frame lip.

Always wash the hatch with soap, water and a soft cloth.

Never use abrasive or solvent cleaners on the acrylic lid, as this may at a later date damage the acrylic.

To avoid risk of injury care should be taken to keep hands and limbs clear of lever and lid pinch zones while operating and adjusting the hatch.

Friction lever adjustment

The friction lever units installed on Concept Circular hatches are pre-set when manufactured to give correct positioning with a minimum opening load. It may be necessary occasionally to adjust the lever setting to correct the operation of the hatch.

Adjustment is made by means of the socket head screws on either side of the lever assembly.

Using a 4mm (5/32") hexagon key, turn the adjusting screw approximately 1/8th of a turn in a clockwise direction to increase the positioning force. This is most easily carried out in the fully open or closed positions.

Do not over tighten the adjusting screws

Open the hatch and check for correct operation.

Re-adjust if necessary until the desired operation is achieved.

Lubricants should not be used on the friction lever assemblies as this will adversely affect the function of the units.

Previous Page - Page 2 of 2

Image 32
Contents Hatch Spares Book Volume Hatch & Portlight Product Marking & Date Coding Lewmar Hatch Identification Abcd SuperhatchSize Rollstop Hatch Trimline Hatch Coastline Hatch Trimport Hatch Also known as Coastline sizes 00 to 24, 33, 41Ocean Hatch Concept Trims, Flyscreens & Accessories Trims & Flyscreens Plastic Trim & Alloy Framed Flyscreen=OC Elasticated Flyscreens, Alloy Trims & Trimkits Please Turn Over Please Turn Over Trimline Hatch Fitting & Adjustment Instructions User Notes Page Page Page Page Page Page Trimport / Coastline Fitting & Adjustment Instructions Friction lever adjustment Ocean Hatch Fitting & Adjustment Instructions Catalogue No Thread Size Concept Hatch Fitting & Adjustment Instructions Do not lock the levers in the ventilation position Concept Circular Hatch Fitting & Adjustment Instructions Previous Page Page 2 Page Page Superhatch Left Handle KIT Part NumberSuperhatch Plastic Corner Catch Block Superhatch Hinge Kits Superhatch Seal Kits ACRYLIC/HINGE Fastening Size 6 Hinge PIN KIT Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Hatch Retro FIT Lock & KEY Fitting Instructions Page Page Page Page Page Page Page Page Page Lewmar Limited Warranty Liability Terms and Conditions of Sale