5-6-7 FT. FINISHING MOWER
TO REPLACE BELT:
STEP 1 | Remove top cover. |
STEP 2 | Release adjustment spring. |
STEP 3 | Loosen nut on adjustment pulley to allow for movement. (See Fig- |
| ure “D”) |
STEP 4 | Loosen nut on right side of “L” bracket. (See Figure “D”) |
STEP 5 | Loosen belt by moving adjustment pulley in opposite direction you |
| would to tighten belt. |
STEP 6 | Remove nuts (2) from hinged gearbox plate from finishing mower |
| deck. (See Figure E) |
STEP 7 | Loosen nuts (2) from hinged bolt gearbox plate. |
STEP 8 | Raise gearbox assembly and slip out belt. |
STEP 9 | See Figure D for belt placement on pulleys. |
STEP 10 | Do step 5 thru 7 under Section: "TO ADJUST BELT" to tighten. |
TO ADJUST BELT:
STEP 1 Remove top cover.
STEP 2 Release adjustment spring.
STEP 3 Loosen nut on adjustment pulley to allow for movement. (See Fig- ure D )
STEP 4 Loosen nut on right side of “L” bracket. (See Figure D)
STEP 5 Turn nut on left side of “L” bracket in counter clockwise direction until belt is tight.
STEP 6
STEP 7
22