PTO SHAFTS COVER REMOVAL (Pictures are on next page) BONDIOLI- (BYPY)
1). There are 3 white tabs around the cover as shown in (A in FIG. 1). Take a screwdriver and press against the tabs one at a time with downward an- gular pressure toward the end of shaft marked (B in FIG. 2). As you are pressing tab grasp cover at point marked (B in FIG. 2) and apply pres- sure against cover in the direction of arrow, do this for each tab. (Some- times the other tabs may relock, if they do you must repeat unlock proce- dure.) You will feel it click when the tab releases, after all 3 tabs are re- leased you can slide the cover down the shaft in direction of (C in FIG. 2).
2)To put cover back into place slide cover back toward end until all the tabs relock. (You may have to tap lightly with screwdriver or hammer handle).
NOTE: Cover may be longer on some models but, they will come off the same as above.
EUROCARDAN SERIES 4
1)First you must locate the black tab (D in FIG. 3) put flat screwdriver in slot in end of tab and turn until the flat side is pointing towards center of shaft. Once you do this take the thin flat screwdriver and put into slot labeled (E in FIG. 3) pry tab all the way out as shown in (FIG. 3)
2). There are 3 white tabs around the cover as shown in (G in FIG. 4). You must line up cover slots and tabs (as shown in FIG. 4, F & G) Take a screwdriver and press against the tabs one at a time with downward an- gular pressure toward the end of shaft. As you are pressing tab grasp cover and apply pressure against cover in the direction of arrow,(H in
3)To put cover back into place slide cover back toward end (be sure tabs and slots line up) until all the tabs relock. (You may have to tap lightly with screwdriver or hammer handle). Once they have relocked replace black tab that was removed with flat side toward shaft center then turn flat side
up to lock in place.
LA MAGDALENA
1)There are 3 black tabs around the cover (K in FIG. 5). Take a screwdriver and press against the tabs one at a time with downward angular pressure toward the end of shaft marked (J in FIG. 5). As you are pressing tab grasp cover at point marked (J in FIG. 5) and apply pressure against cover in the direction of arrow, do this for each tab.
2)To replace slide cover back toward end and line up black tabs with the holes and lock in place.
37