King Kutter 999998 manual Sizing PTO Shaft Step

SIZING PTO SHAFT

STEP 1

Cutting the PTO shaft to length. NOTE: Be sure to cut equal lengths of each PTO shaft section. Clamp end of PTO shaft in a vice and cut off shield where marked. (Figure 1-A & 1-B)

STEP 2

Using cut section of the shield as a guide cut shaft off the same amount. (Figure 2)

STEP 3

Repeat steps 1 and 2 for other PTO shaft section.

STEP 4

Use a file to deburr PTO shafts. Clean up all chips, burrs and filings from both ends of the PTO shaft.

Note: If you shear the bolt that attaches the PTO shaft to the gearbox re- place with a grade 2 bolt only. Re- placement with another grade of bolt will void your warranty and may cause terminal damage to the PTO shaft, gearbox, or tractor.

Figure 1-A

Figure 1-B

Figure 2

19