King Kutter 999998 manual Rotary Mower Operation Step

Page 21

Note: For best results in heavier cutting conditions adjust the deck so the rear of the mower is approximately 2" higher than the front. This method requires less horse- power and ground speeds of approximately 3-5mph. If finer shredding results are de- sired, adjust the deck to level or slightly lower in the rear. This method will keep foli- age under the deck longer resulting in finer pieces. The down side of this method is if it takes a lot more horsepower and very slow ground speed. This method is not rec- ommended unless a PTO speed of 540 RPM can be maintained.

ROTARY MOWER OPERATION

STEP 1

Before each use perform the maintenance described in maintenance section. (page 22)

STEP2

Read, understand, and follow the information on safety training, preparation, starting and stopping safety, operational safety, transport safety warning sections of this man- ual (pages 11 thru 16)

STEP 3

With tractor running, lower rotary mower into working position.

STEP 4

With the tractor at idle RPM, engage PTO and slowly advance throttle to 540 PTO RPM. NOTE: Rotary mower designed to run at 540 PTO RPM only.

STEP 5

Select a low gear for the tractor and begin to mow. Tractor ground speed is to be controlled by gear selection only and not engine speed. Tractor ground speed should allow rotary mower to maintain 540 PTO RPM and thus maximum blade tip speed.

NOTE: Do not allow the tractor engine or rotary mower to bog down or stall. This causes undue wear and tear on the mower and tractor. If this continues to happen re- duce ground speed and raise cutting height of rotary mower until the 540 PTO RPM is able to be maintained.

Never attempt to clean out a plugged discharge chute until the tractor has been shut down and the mower blades have completely stopped.

STEP 6

After each use clean all debris from the top and bottom of the rotary mower. Re- place any missing or illegible safety decals. Inspect for any damaged or worn parts and replace before next use. Store rotary mower in a dry environment.

21

Image 21
Contents Rotary Mower Operation and Parts Manual Page To the Purchaser Page Contents Signal Words SafetyEquipment Safety Guidelines Rotary Mower Assembly Instructions Step Figure a Figure E Shipped with OIL in Gearbox Before Putting Rotary Mower Into ServiceSafety Training Prepartion Starting and Stopping SafetyOperational Safety Operational Safety Transport Safety Attaching to Tractor Attaching to Tractor Sizing PTO Shaft Step PRE-OPERATIONAL Adjustments Cutting Height AdjustmentOperating Instructions Rotary Mower Operation Step Grease points Joints MaintenanceStorage Safety Maintenance SafetySafety Sign Locations Page Page Page Model no Description SN# Part Name 147022 147029 147034 Shear PIN PTO ShaftPart Name 147129 Slip Clutch PTO ShaftPart Name Slip Clutch AssemblyPart Name Number Rotary Mower Size Rotary MOWER- LiftPart Name Number ’ Heavy Duty Lift Mower’- 60hp ’- 80hp ’ 60hp ’ 80hp Heavy Duty Lift 6’ & 7’ MowerRotary MOWER- Pull 84-60-HD Part Name Part NumberBONDIOLI- Bypy Eurocardan SeriesLA Magdalena Page PTO Shafts Cover Removal Eurocardan Series HP Gearbox Part Name Gearbox HP Gearbox Gearbox HP Gearbox Part Name Gearbox Limited Warranty