CONTENTS
Before using a new saw
•Read the instructions carefully.
•Check cutting equipment is correctly fitted and adjusted. See page 25.
•Refuel and start the saw. Check the carburetor settings. See pages
•Do not use the saw until sufficient chain oil has reached the chain, see page 14.
IMPORTANT! If the carburetor mixture is too lean it greatly increases the risk of engine failure.
Poor maintenance of the air filter will cause carbon
If the chain is badly adjusted it will cause increased wear or damage to the bar, drive sprocket and chain.
Maintenance, replacement, or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual.
WARNING!
Under no circumstances may the design of the machine be modified without the permis- sion of the manufacturer. Always use genuine spare parts/accessories.
Your warranty may not cover damage or liability caused by the use of
A chain saw is a dangerous tool if used carelessly or incorrectly and can cause serious, even fatal injuries. It is very important that you read and understand these instructions.
You will find the following labels
on your chain saw:
Contents
Key to symbols | 2 | ||
Safety instructions |
| ||
Personal protective equipment | 4 | ||
Chain saw safety equipment | 4 | ||
Inspecting, maintaining and servicing chain saw safety |
| ||
equipment | 8 | ||
Cutting equipment | 10 | ||
How to avoid kickback | 16 | ||
General safety precautions | 18 | ||
General working instructions | 19 | ||
What is what? |
| ||
What is what? | 24 | ||
Assembly |
| ||
Mounting guide bar and chain | 25 | ||
Fuel handling |
| ||
Fuelmix | 26 | ||
Fuelling | 27 | ||
Start and stop |
| ||
Start and stop | 28 | ||
Maintenance |
| ||
Carburetor | 29 | ||
Starter device | 30 | ||
Air filter | 31 | ||
Spark plug | 31 | ||
Muffler | 31 | ||
Needle bearing maintenance | 31 | ||
Adjustment of the oil pump | 31 | ||
Cooling system | 32 | ||
Centrifugal cleaning ”Turbo” | 32 | ||
Winter use | 32 | ||
Daily maintenance | 33 | ||
Weekly maintenance | 33 | ||
Monthly maintenance | 33 | ||
Technical data |
| ||
2141 | .................................................................................. |
| 34 |
2145 | .................................................................................. |
| 34 |
2150 | .................................................................................. |
| 34 |
Federal Emission Control |
| ||
Warranty Statement |
| ||
Your warranty rights and obligations | 35 | ||
|
|
|
|
|
|
|
|
|
|
|
|
The Emissions Compliance Period reffered to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements.
Category C = 50 hours, B = 125 hours, A = 300 hours.
Jonsered has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice.
English – 3