MAINTENANCE
Starter device
!WARNING!
•When the recoil spring is assembled in the starter housing, it is in tensioned position and can when treated carelessly, pop out and cause injuries.
•Always be careful, when changing the recoil spring or the starter cord. Always wear safety goggles for eye protection.
Changing a broken or worn starter cord
• Loosen the screws, that hold the starter device against the crankcase and remove the starter device.
•Pull out the cord approx. 30
cm and lift it up into the notch in the pulley.
•Insert and fasten a new starter cord in the pulley. Wind approx. 3 turns of the
starter cord on to the pulley. Assemble the starter pulley against the recoil spring, so the end of the spring engages to the pulley. Fit the screw in the centre of the pulley. Carry the starter cord through the hole in the starter housing and the starter handle. Make a knot on the starter cord.
Tensioning the recoil spring
•Lift the starter cord up in the notch on the starter pulley and turn the starter pulley 2 turns clockwise.
NOTE! Check that the starter pulley can be turned at least half a turn, when the starter cord is entirely pulled out.
Changing the broken recoil spring
•Lift the starter pulley (see "Changing a broken or worn
starter cord").
• Dissasemble the recoil spring by tapping the pully (with its inside facing down) lightly against a working bench or similar. If the spring pops out when assembling, it should be mounted again, out and in towards the centre.
•Lubricate the recoil spring with thin oil. Assemble the starter pulley, and tension the recoil spring.
Starter device assembly
•Assemble the starter device, by pulling the starter cord out first, then place the
starter against the crankcase. Then slowly release the starter cord so that the pulley engages with the pawls.
• Assemble and tighten the screws, which hold the starter.
30 – English