MAINTENANCE INSTRUCTIONS
ENGLISH
Suction/Intake Cover/Strainer Maintenance
Clean the suction/intake cover/strainer of hair and debris when necessary. To do this, remove the center screw and detach the square cover. Clean the cover by backflushing debris from the holes. Replace the suction/intake cover im- mediately after cleaning. When reinstalling, orient the cover/ strainer with the small notch at the bottom. The gasket must be inserted into the groove of the cover/strainer before rein- stalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches (15,2 cm) away from the suction/intake fitting at all times when the whirlpool system is operating. Hair longer than shoulder length should be secured close to the head, or a bathing cap should be worn. Do not operate the whirlpool sys- tem with the suction/intake cover removed! It is a safety device and must always be in place on the suction fitting to minimize the potential hazard of hair and/or body en- trapment.
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SUCTION
FITTING
SCREW
NOTCHGASKET
Lighting (Chromotherapy lighting)
Your unit has Chromotherapy (LED) lighting. If the lights fail to function contact your Jacuzzi Whirlpool Bath dealer. There are no customer serviceable components on the Chro- motherapy lighting.
Replacement fixtures are available from your Jacuzzi Whirlpool Bath dealer.
LED LIGHT ASSEMBLY
LOCKING NUT
LIGHT BEZEL
SHELL
Lighting (optional IllumatherapyTM lighting)
If your unit has Illumatherapy (fiberoptic) lighting and the lights fail to function contact your Jacuzzi Whirlpool Bath dealer. There are no customer serviceable components on the Illumatherapy lighting.
Replacement fixtures are available from your Jacuzzi Whirlpool Bath dealer.
JET WITH FIBEROPTIC LIGHTS
DIN BOX (MOUNTED
ONTO FIBERGLASS SHELL)
LOCKING NUT
LIGHT BEZEL
FIBEROPTIC CABLE (ROUTED TO WHIRLPOOL CONTROL BOX)
SHELL
FIBEROPTIC CABLES
ROUTED FROM JET TO DIN BOX
24
Jacuzzi Whirlpool Bath K339000X 3/06