Homelite UT70131, F3040 manual Assembly, Front Handle, Attaching the Shoulder Strap

Page 7

ASSEMBLY

FRONT HANDLE

See Figure 2.

A barrier handle should be used for ensuring the best control and maximising operator safety.

1.Hold the top and bottom clamp snugly in position on the shaft housing so that handle will be located to the operator’s left.

2.Insert the end of the handle between the clamps.

3.Align the bolt holes and push the long bolt (1/4-20 x 1 1/2 in) through the handle side.

4.Place short bolt (1/4-20 x 1 in) through opposite side of clamp. Install flat washer, lock washers and hex nuts to hold the assembly in place.

5.After assembly is complete, adjust the position of the handle for best balance and comfort.

6.Tighten first the long bolt and then the short bolt.

7.Connect the shoulder strap to the strap hanger adjust to a comfortable position.

NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See Figure 4.

ATTACHING THE SHOULDER STRAP

See Figure 3.

1.Connect the latch on the shoulder strap to the strap hanger.

2.Adjust the strap to a comfortable position.

NOTE: To quickly release the product from the shoulder strap, sharply pull the quick release tab.

BOLT

1/4-20 x 1 in

FRONT

BOLT

1/4-20 x 1 1/2 in

HANDLE

 

STRAP

HANGER

SPACER CLAMP

FLAT WASHER

CLAMP

HEX NUT

LOCK WASHER

Fig. 2

SHOULDER

QUICK

STRAP

RELEASE

TAB

LATCH

STRAP

HANGER

Fig. 3

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Save this Manual for Future Reference OPERATOR’S ManualSafety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsTechnical Data Packing List for OWNER’S KIT FeaturesUnpacking InstructionsFront Handle AssemblyAttaching the Shoulder Strap Grass Deflector and Blade Guard USE Silencer Guard AssemblyGrass Deflector Blade GuardConverting from Trimmer to Brushcutter Removing the Blade Installing the BladeInstalling the String Head Converting from Brushcutter to TrimmerFuel and Refuelling OperationOperating the Trimmer Cutting Tips Advancing the StringGrass Deflector Line Trimming CUT-OFF Blade TRI-ARC Blade Operating the BrushcutterCutting Technique Blade To Start a Warm Engine Ignition SwitchStarting and Stopping To Start a Cold EngineSee Figures 16 MaintenanceSpool Replacement EZ Line TAP Advance System NEW PRE-WOUND SpoolBlade Protector Latch Pull Cover To Open Filter Cleaning the Exhaust Port and SilencerReplacing and Cleaning AIR Filter Spark ArresterStorage 1 Month or Longer Fuel CAPSparking Plug Dealer. See Figure TroubleshootingIdle Speed Screw Needle Sound Pressure Sound Power Vibration Model Model no WarrantySafety Directive Guarantee Statement Rtsa / Rtuk / RTGRyobi Technologies GmbH
Top Page Image Contents