Homelite UT08981, UT08580 manual Operating the Blower, Proper operating Position

Page 12

operation

WARNING:

Keep away from all hot surfaces of the blower. Failure to do so could result in possible serious personal injury.

OPERATING THE BLOWER

See Figure 9.

nSlip arm through harness strap and onto shoulder, then repeat for the other shoulder. Adjust the straps to a comfortable position. Refer to Adjusting Harness Straps earlier in this manual. Remove unit for starting.

nStart the blower. Refer to Starting and Stopping earlier in this manual.

nPut on the blower again. The unit should be operated from the right side as shown.

nTo keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile.

nOperate power equipment at reasonable hours only

— not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordinances.

nTo reduce sound levels, limit the number of pieces of equipment used at any one time.

nOperate blower at the lowest possible throttle speed to do the job.

nCheck your equipment before operation, especially the muffler, air intakes, and air filters.

nUse rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when water is available.

nConserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens.

nWatch out for children, pets, open windows, or freshly washed cars, and blow debris safely away.

proper operating

position

Fig. 9

nUse the wide sweeper nozzle for larger volume, so the air stream can work close to the ground.

nAfter using blowers or other equipment, CLEAN UP! Dispose of debris properly.

Caution:

Do not place blower on top of or near loose debris. Debris may be sucked into blower intake vent resulting in possible damage to the unit.

Page 12

Image 12
Contents UT08580/UT08981 ALL VersionsTable of contents IntroductionGeneral safety rules Specific safety rules Symbols Symbol Name ExplanationService Symbol Signal MeaningFeatures Product SpecificationsAssembly Assembling the Blower Tubes See Figures 2Adjusting Harness Straps OperationApplications Fueling and Refueling Fuel MixtureStarting and Stopping To Stop the EngineSee Figures 6 For Help CallOperating the Blower Proper operating PositionMaintenance General MaintenanceCleaning the AIR Filter Screen LubricationCleaning the Exhaust Port and Muffler Spark PlugSpark Arrestor Fuel CAPTroubleshooting Problem Possible Cause SolutionWarranty Limited Warranty StatementYour Warranty Rights and Obligations Make the Most of Your Purchase Page Parts and Service