assembly
WARNING:
Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figures 2 - 5.
nPlace large clamp on the elbow tube and install the elbow tube onto blower. Tighten large clamp securely.
nPlace large clamp on the bellows and install the bellows onto the elbow. Tighten clamp securely.
nInsert upper tube into throttle control handle. Position the throttle control handle in the center of upper tube and tighten thumb screw securely.
NOTE: The position of the throttle control handle may be adjusted for the best comfort after the blower is strapped onto the operator’s back.
nPlace small clamp on the bottom end of the bellows and install the upper tube onto the bellows; tighten clamp securely.
nJoin upper tube to lower tube and tighten securely.
nThread nozzle onto lower tube and tighten securely.
nTighten all threaded joints securely.
NOTE: Check all threaded joints after initial run to ensure they are tightened securely.
nHold the throttle cable against the bellows and install the cable ties. Cable ties should be tight enough to retain the throttle cable to the bellows but still allow for movement.
large 
clampS
small clamp
elbow | bellows | upper |
|
tube | tube | TUBE | Fig. 2 |
|
|
|
throttle control handle
throttle cable
upper TUBE
THUMB screw
Fig. 3
lower
tube
WIDE SWEEPER
NOZZLE
Fig. 4
throttle
cable
cable |
|
ties | Fig. 5 |
|
Page