Kickback Precautions, Fuel and Refueling

OPERATION

KICKBACK PRECAUTIONS

See Figures 6 and 7.

Rotational kickback occurs when the moving chain con- tacts an object at the Kickback Danger Zone of the guide bar. The result is a lightning fast, reverse reaction which kicks the guide bar up and back towards the operator. This reaction can cause loss of control which can result in serious injury.

KICKBACK DANGER

ZONE

Fig. 6

ROTATIONAL

KICKBACK

Fig. 7

WARNING:

Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. (9 m) from refueling site before starting the engine. DO NOT SMOKE! Failure to heed this warning can result in possible personal injury.

FUEL AND REFUELING

HANDLING THE FUEL SAFELY

See Figure 8.

WARNING:

Check for fuel leaks, if any are found, correct them before using the saw to prevent fire or burn injury.

■Always handle fuel with care, it is highly flammable.

■Always refuel outdoors and do not inhale fuel vapors.

■Do not let gasoline or oil come in contact with skin.

■Keep gasoline and oil away from the eyes. If gasoline or oil comes in contact with the eyes, wash them immediately with clean water. If irritation is still present, see a doctor immediately.

■Clean up spilled fuel immediately.

MIXING THE FUEL

■This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-cycle engine oil in a clean container approved for gasoline.

■This engine is certified to operate on unleaded gasoline intended for automotive use with an octane rating of 87 ([R + M] / 2) or higher.

■Do not use any type of pre-mixed gasoline/oil from fuel service stations, this includes the pre-mixed gasoline/oil intended for use in mopeds, motorcycles, etc.

■Use a high quality 2-cycle self-mixing oil for air-cooled engines. DO NOT use automotive oil or 2-cycle out- board oil.

■Mix 2% oil into the gasoline. This is a 50:1 ratio.

■Mix the fuel thoroughly and each time before fueling.

■Mix in small quantities. Do not mix quantities larger than usable in a 30-day period. A 2-cycle oil containing a fuel stabilizer is recommended.

50:1

GAS
OIL	FUEL MIX
	FUEL MIX

FILLING THE TANK

See Figure 8.

Refer to “Specific Safety Rules – Refueling” earlier in this manual for additional safety information.

1.Clean the surface around fuel cap to prevent contamina- tion.

2.Loosen the fuel cap slowly.

3.Carefully pour the fuel mixture into the tank. Avoid spillage.

4.Prior to replacing the fuel cap, clean and inspect the gasket.

5.Immediately replace the fuel cap and hand tighten. Wipe up any fuel spillage.

Note: It is normal for the engine to emit smoke during and after the first use.

					50:1
GAS		OIL			FUEL MIX






1 Quart	+	.67 oz.	=	}
2 Quart	+	1.35 oz.	=		50:1
3 Quart	+	2.0 oz.	=		50:1
4 Quart	+	2.7 oz.	=
5 Quart	+	3.38 oz.	=

Page 10

OPERATION