troubleshooting
Problem | Possible Cause | Solution |
Engine will not start. | No spark. | Check spark. Remove spark plug. Reattach |
|
| the spark plug cap and lay spark plug on |
|
| metal cylinder. Pull the starter rope and |
|
| watch for spark at spark plug tip. If there |
|
| is no spark, repeat test with a new spark |
|
| plug. |
| No fuel. | Push primer bulb until bulb is full of fuel. |
|
| If bulb does not fill, primary fuel delivery |
|
| system is blocked. Contact a servicing |
|
| dealer. If primer bulb fills, engine may be |
|
| flooded, proceed to next item. |
| Engine is flooded. | Remove spark plug, turn blower so spark |
|
| plug hole is aimed at the ground. Rotate the |
|
| choke dial to “RUN” position and pull starter |
|
| cord 10 to 15 times. This will clear excess |
|
| fuel from engine. Clean and reinstall spark |
|
| plug. Pull starter three times with choke dial |
|
| at “RUN”. If engine does not start, rotate |
|
| choke dial to “FULL CHOKE” position and |
|
| repeat normal starting procedure. If engine |
|
| still fails to start, repeat procedure with a |
|
| new spark plug. |
| Starter rope pulls harder now than when | Contact a servicing dealer. |
| new. |
|
|
|
|
Engine starts but will not accelerate. | Engine requires approximately three | Allow engine to completely warm up. If |
| minutes to warm up. | engine does not accelerate after three |
|
| minutes, contact a servicing dealer. |
|
|
|
Engine starts but will only run at high speed | Carburetor requires adjustment. | Contact a servicing dealer. |
at half choke. |
|
|
|
|
|
Engine does not reach full speed and emits | Check lubricant fuel mixture. | Use fresh fuel and the correct |
excessive smoke. |
| lubricant mix. |
| Air filter is dirty. | Clean air filter. Refer to Cleaning the Air |
|
| Filter Screen earlier in this manual. |
| Spark arrestor screen is dirty. | Contact a servicing dealer. |
|
|
|
Page 14