Homelite UT08921 manual Assembling the Blower Tube, Attaching the handle

Page 8

assembly

WARNING:

Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.

ASSEMBLING THE BLOWER TUBE

See Figure 2.

Align the flat side of the blower tube with the flat side of the blower.

NOTE: Homelite logo will be face up.

Push blower tube into blower housing until the tube latch snaps into place.

To remove the tube, lift the tube latch with a screwdriver and remove tube from the blower housing outlet.

Attaching the handle

See Figure 3.

Position handle so that the screw hole is facing outward.

Insert handle into blower handle compartment until the handle snaps into place.

Secure handle in place with the provided screw.

snap

blower tube

Fig. 2

handle

screw hole

screw

Page 

snap

Fig. 3

Page 7 Page 9
Image 8
Page 7 Page 9
Contents OPERATOR’S Manual UT08520/UT08921Table of contents IntroductionGeneral safety rules Specific safety rulesSymbols Symbol NameService Features Product SpecificationsAssembly Know Your blowerRotochoke Zip Start UnpackingAssembling the Blower Tube Attaching the handleOperation ApplicationsFueling and Refueling Fuel Mixture Filling TankStarting and Stopping To Stop the EngineIf assistance is required Starting this product See Figures 4Operating the blower See Figures 7Maintenance General MaintenanceCleaning the AIR Filter Screen LubricationCleaning the Exhaust Port and Muffler Spark PlugSpark Arrestor Fuel CAPTroubleshooting Problem Possible Cause SolutionWarranty Limited Warranty StatementYour Warranty Rights and Obligations Emissions Maintenance Schedule and Warranted Parts List This product was manufactured with a catalyst mufflerParts and Service California Proposition
Top Page Image Contents