ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
PACKING LIST
Blower
Upper Blower Tube Wide Sweeper Nozzle Tube Clamp
Operator’s Manual
NOTE: Read and remove all hang tags and store with your operator’s manual.
WARNING:
If any parts are missing do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such altera- tion or modification is misuse and could result in a hazard- ous condition leading to possible serious personal injury.
WARNING:
Disconnect spark plug wire before assembling product. Failure to do so could result in possible serious injury.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
nScrew the nozzle onto the upper blower tube and tighten securely. Check tightness after initial run and retighten if needed.
nPlace clamp around the neck of the blower housing outlet. Do not tighten the wing nut yet.
nAlign the locking tab on upper blower tube with the slot in the blower housing outlet; push the tube into the housing. Twist to lock into place.
nRotate the tube so the nozzle is pointing upward as shown. Tighten the wing nut securely.
nTo remove the tubes, loosen the wing nut on the clamp. Rotate the tubes to unlock them and then remove then from the blower housing outlet.
WING NUT
NOZZLE | UPPER TUBE |
Fig. 2
Page 7