Hilti JP626, JP328 Operating Instructions Safety, Surface Units, Drip Pans, Lift-Up Cooktop

Instructions

Care and cleaning of the cooktop.

Operating Instructions Safety

Lift the surface unit about 1 inch above the drip pan and pull it out.

Surface Units

To clean the surface units, turn the control to the highest setting for a minute. The coils will burn off any soil.

To remove a surface unit:

To remove the drip pans for cleaning, the surface units must be removed first.

Lift the surface unit about 1 inch above the drip pan and pull it out.

Do not lift the surface unit more than 1 inch. If you do, it may not lie flat on the drip pan when you plug it back in.

Repeated lifting of the surface unit more than 1 inch above the drip pan can permanently damage the receptacle.

To replace a surface unit:

Replace the drip pan into the recess in the cooktop. Make sure the opening in the pan lines up with the receptacle.

Insert the terminals of the surface unit through the opening in the drip pan and into the receptacle.

Guide the surface unit into place so it rests evenly.

Do not immerse the surface units in liquids of any kind.

Do not clean the surface units in a dishwasher. Do not bend the surface unit plug terminals.

Do not attempt to clean, adjust or in any way repair the plug-in receptacle.

Care and Cleaning

Receptacle

Drip pan

Drip Pans

Remove the surface units. Then lift out the drip pans.

Clean the drip pans by hand with warm, soapy water.

To remove burned-on foods, soak them in hot, soapy water for several hours. Then scrub with a soap-filled plastic scouring pad if necessary.

Rinse with clean water and polish with a clean soft cloth.

The drip pans may also be cleaned in a dishwasher.

Clean the area under the drip pans often. Built-up soil, especially grease, may catch fire.

Do not cover the drip pans with foil. Using foil so close to the receptacle could cause shock, fire or damage to the cooktop.

Consumer Support Troubleshooting Tips

Support rod

Be sure to secure the cooktop support rod in the cooktop front lip.

Lift-Up Cooktop

Clean the area under the cooktop often. Built-up soil, especially grease, may catch on fire.

To make cleaning easier, the entire cooktop may be lifted. Be sure all surface units are turned off and are cool before raising the cooktop.

To raise the cooktop:

1 Remove all four control knobs. See the Control Knobs section.

2 Remove one of the front surface units and drip pans and use this opening to grasp the cooktop. See the Surface Units and Drip Pans sections.

3 Lift the cooktop.

4 Raise the support rod into place and hook it onto the front lip of the cooktop to hold it in place while cleaning.

To clean the cooktop:

Use hot, soapy water and a clean cloth to clean the surface under the cooktop. To remove burned-on spills, use a cleansing powder. Rinse well, then polish with a dry cloth.

To lower the cooktop:

	While holding the cooktop up with
1
	one hand, carefully disengage the
	support rod and return it to its
	original location.
	Gently lower the cooktop.
2
	Replace any drip pans and surface
3
	units that you removed.
	Replace the control knobs.
4

8