Assembly (continued)
Note: When deciding where to mount the
sink, make sure the wall can handle the FIGURE 3 weight of the sink and at least the weight of
10.5gallons of water (8 Lbs. per gallon). We recommend mounting into wall studs. Plan the Sink to be located near the water source.
Refer to FIGURES 1,2,3,4,5.
1.Attach the two Wall Supports (#3) to the Sink by meshing together the Pins on the Wall Supports (#3) next to the Pin Holes on underside of each side of the Sink.See FIGURE 2. Once the Sink is fully attached to the Wall Supports (#3), fit the four Mounting Brackets (#1) onto the
Rectangular Support Ends on each Wall Support (#3). The Mounting Brackets (#1) will fit into the gap between the Rectangular Support End and the vertical bar of the Wall
Support (#3). Hold the Sink, with the | Rectangular |
| FIGURE 4 |
| ||
supports and brackets, up against the |
|
| ||||
|
|
|
| |||
Support Ends |
|
|
|
| ||
wall. Use a level to make sure the Sink |
|
|
|
| ||
|
|
|
|
|
| |
is perpendicular to the ground, and mark |
|
|
|
|
|
|
|
|
|
|
|
| |
where each screw hole on the |
|
|
|
|
|
|
Mounting Brackets (#1) should go. |
|
|
|
|
|
|
After marking your mounting spots, |
|
|
|
|
|
|
|
|
|
|
|
| |
detach the Sink from the |
|
|
|
|
|
|
Wall Supports (#3), and remove the |
|
|
|
|
|
|
Mounting Brackets (#1) from the |
|
|
|
|
|
|
|
|
| Wall Supports (#3) |
| ||
Wall Supports (#3). |
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| Mounting Bracket (#1) |
| ||
2. Screw the Mounting Brackets (#1) to |
|
|
|
|
|
|
the wall (screws not included). See |
|
|
|
|
|
|
FIGURE 3. |
|
|
|
|
|
|
| FIGURE 5 |
|
|
|
| |
|
|
|
|
|
| |
3.Fit the four Rectangular Support Ends on each Wall Support (#3) into the gap between the Rectangular Support End and the vertical bar of the Wall
Support (#3). See FIGURE 4. | Pins |
|
4. Fit the three Pins on each Wall Support (#3) to the Sink by meshing together the Pins on the Wall Supports (#3) with the corresponding Pin Holes on underside of each side of the Sink.
SKU 90326 | Page 5 |