Assembly (continued)
5.To install the Drain Set (#11):Set the Drain Ring into the hole in the Sink. Hold the Gasket and the Funnel under the Sink in positionunder the hole. Attach them with the screw. See FIGURES 2 and 6.
6.Attach the Elbow (#9) to the Funnel with the Connector (#10). See FIGURE 6.
7.Attach the Pipe (#8) into the Elbow (#9) in the bottom, and the piece of pipe coming from the upper drain on the top.
See FIGURES 2 and 6.
8.Set the Spout (#6) into the hole next
to the upper drain and connect it under the Sink with the Spout Connector (#6). Attach the Intake Coupler (#12) to the Spout Connector (#6).
9.Attach a 3/4” hose (not included) to the threaded Water Inlet. See FIGURE 2. Attach a 3/4” hose using hose clamps (not included) to the Water Outlet. Route hose to your planned location for waste water exit.
10.Check the Sink and all the fittings for leaks and that it properly drains. Once you’re sure that everything is satisfactory, the Sink is ready for use.
Note: The small tray and the washboard tray easily set in the top of the Sink when needed. See the cover photo.
Maintenance
1.Periodically check that all of the connections are tight.
2.Keep the drain clear of all obstructions.
FIGURE 6
Screw
Drain Ring
Gasket
Funnel
FIGURE 7
FIGURE 8
SKU 90326 | Page 6 |