Dispose of spent batteries according to your local, state and federal regulations.
Note: You can extend battery life by using earphones, which require less power than the
Note: Replace batteries when the LOW BATT light turns on in the View Meter (36).
Headphones
1.Insert headphone (sold separately) jack into Earphone socket.
2.To protect your hearing, set the On/ Off/Volume Control to OFF before using the earphones, then adjust the level to the lowest setting before you begin listening.
3.Do not listen at extremely high volume levels. Extended high volume listening can lead to permanent hearing loss.
4.Do not wear headphones while operating your detector near high- trafffic areas. Pay attention to traffic safety.
Functions and Indicators
On/Off/Volume - Turns on power to the
unit and sets the sound level.
SENS - Sets the sensitivity level of the unit. Zero setting is the lowest level and 10 is the highest. For general use, set the sensitivity to a higher position. In a mineralized area, or area with electrical interference, a lower setting may be more effective.
MODE - Sets the unit to three modes: DISC, ALL METAL and TONE.
Target Button - It is used with ALL METAL mode to pinpoint a target object’s location.
DISC/TONE - Adjustment knob for metal identification.
View Meter - Registers signal strength when a metal is detected.
-DISC, ALL METAL, and TONE are motion modes. You have to move the
Search Coil to find your target object.
-Target Mode is for pinpointing the location of the item when the item is below the surface.
|
|
|
|
| LOW | |
View |
|
|
|
| BATTERY | |
Meter |
|
|
|
| Indicator | |
|
| |||||
(36) |
|
|
|
| Target | |
|
|
|
|
| Button (6) | |
On/Off/ |
|
|
|
| DISC/TONE | |
VOLUME |
|
|
|
| ||
(35) | ||||||
(34) | ||||||
|
|
|
|
| ||
SENS |
|
|
|
| MODE | |
|
|
| ||||
(33) |
|
|
|
| Switch (1) | |
Earphone Socket | Figure 3 |
(11) |
SKU 67378 | For technical questions, please call | Page 7 |