Global Machinery Company G25 instruction manual Spark plugs, Engine oil replacement, Air filter

Page 16

Spark plugs

Q

 

1.Remove spark plug maintenance cover (9) from the generator housing (Fig. Q).

2.Remove the spark plug lead (Fig. R).

3.Remove any dirt from around the spark plug base.

R

 

S

 

 

 

4.With the spark plug wrench provided remove the spark plug (Fig. S).

5.Visually inspect the spark plug. Remove carbon deposits using a wire brush.

6.Check for discoloration on the top of the spark plug. The standard colour should be a tan colour.

7.Check the spark plug gap. The acceptable gap should be between 0.6–0.7mm.

8.Install/reinstall the spark plug carefully by hand.

9.Once the spark pug has been seated tighten with the spark plug wrench.

10.Reinstall the spark plug cap on top of the spark plug.

11.Reinstall the spark plug maintenance cover (9)

The recommended spark plugs are as follows: NGK CR7HSA

Engine oil replacement

1.Place the generator on a level surface and warm up the engine for several minutes. Then stop the engine.

2.Loosen the side maintenance cover screw (20) and remove the side maintenance cover.

3.

Remove the oil filler cap (19).

Oil Filler Cap

T

 

 

4.

Drain dirty oil into a container

 

 

 

 

thoroughly by tilting the engine

 

Full Oil Level

 

 

 

 

toward the oil filler neck.

 

 

5.

Once emptied, tilt the generator

 

 

 

back up and place into the

 

 

 

generator up right position.

Low Oil Level

 

6.Refill with recommended oil.

Fill to the upper limit of the filler neck (Fig. T).

Note. The recommended 4 stroke engine oils are either SAE30 (single viscosity) or 10W30 (multi viscosity) 4 stroke oil.

CAUTION. Check that no foreign material, debris, dust enters the crankcase.

7.Reinstall the oil filler cap (19).

8.Reinstall the side maintenance cover (5) and tighten the cover screw (20).

Air filter

It is very important to maintain an air filter in proper condition. Damage to the generator may arise if the filter has:

Improperly been serviced (20).

Dirt and other foreign elements adhering to the filter due to improper installation and engine wear.

ALWAYS keep the filter clean at all times.

1. Remove the side maintenance cover (5) (Fig. U).

U

 

V

 

 

 

2.Remove the air cleaner filter cover by firstly pushing down on the tab on the top of the air cleaner housing (Fig. V). Once the air cleaner filter cover tab has been released out of the filter housing, continue to detach the air filter cover housing by raising the air filter housing cover up and detaching it form the bottom tab.

16

Image 16
Contents 1000W Inverter Generator Contents Description of symbols SpecificationsIntroduction Environmental protectionGeneral safety instructions for power tools Hazard What could happen How to prevent it Operation of unit when damagedOperation of generator in rain, wet Icy, or flooded conditionsRisk of fire Risk of breathing inhalation hazard Risk from liftingTo vehicle surfaces ObjectRisk of unsafe operation Risk of moving partsAdditional safety rules for generators UnpackingKnow your product Inverter technology Including Smart Throttle System Preparing the generatorChecking the engine oil Checking the engine fuelFill the unit to the base Filter housing. do not Fill Starting the engineConnecting apparatus to the generator Overload IndicatorStopping the engine AC ApplicationsDC Applications Charging time HrMaintenance schedule Generator maintenanceStorage Spark plugs Engine oil replacementAir filter Cleaning RepairsTransportation General inspectionTroubleshooting DC circuit breaker GeneratorOverheating Generator stopsRunning rough Appliance is notWorking Or stops workingPage Page Page GMC customer assist