5.Push the choke all the way down.
6.Pull the recoil starter rapidly until the engine starts.
7.Allow the engine to run for 10 seconds to let it warm up.
8.To increase the engine speed squeeze the throttle trigger (1).
Stopping the blower
Stop the engine by pressing the off button (12) and holding it for 2 seconds.
Blowing
Start the blower engine, as previously described. Hold the blower firmly about 10 - 20 cm
from the ground and move it in a sweeping motion from left to right, directing the debris to the desired location.
•Use low throttle settings when clearing lightweight materials from around lawns or shrubbery.
•Use medium to higher throttle settings to move lightweight grass or leaves from driveways or paths.
•Use full throttle when moving heavy loads such as dirt or snow.
IMPORTANT. Blower noise increases at higher throttle settings. Always use the lowest throttle setting required to get the job done.
•Never operate the blower unless it is properly assembled and in good working condition.
•Never operate the blower without a properly functioning muffler and spark arrestor installed.
Use of the petrol blower
•The GMC petrol blower can efficiently move a wide variety of debris ranging from grass clippings to gravel. As a general rule try to operate the blower at the lowers throttle setting necessary to get the job done.
•Prior to use of the blower ensure you have read and understood this instruction manual.
•Ensure you are wearing suitable clothing and also safety equipment like safety glasses, ear protection and a mask if necessary.
•Keep a gap between the air intake and clothing and body parts as this will reduce the performance and may result in injury.
Maintenance
WARNING. Before performing any maintenance on this blower, stop the engine and disconnect the spark plug wire.
Checking the spark plug
Check the spark plug every 10 - 15 hours of use.
1.Remove the spark plug cover.
2.Use a spark plug wrench to remove the spark plug, by turning it
3.Clean and adjust the spark plug gap to 0.6 - 0.7mm. Replace any damaged or visibly worn plug with a CHAMPION CJ8,
NGK BM6A or equivalent spark plug.
4.Install the spark plug finger tight in the cylinder head, then tighten it firmly with the spark plug wrench.
10