Marantz SR5005 manual Input Mode, Sat Dvd Vcr

ENGLISH

		Setting items						Setting details
Progressive Mode								Auto : The video signal is automatically detected and the appropriate
Set an appropriate								mode is set.
progressive conversion								Video1 : Select mode suitable for video playback
mode for the source video								Video2 : Select mode suitable for video and 30-frame film material
signal.								playback.
								This item can be set when “i/p Scaler” is set to anything other than
	BD			DVD			VCR
					z			“OFF”.
	SAT			GAME		AUX1
			z
	TV

	Input Setup
Input Mode	Default settings are underlined.

The input modes available for selection may vary depending on the input source.

Setting items	Setting details
Input Mode	Auto : Automatically detect input signal and perform playback.
Set the audio input modes	HDMI : Play only signals from HDMI input.
for the different input	Digital : Play only signals from digital input.
sources.	Analog : Play only signals from analog input.
	7.1CH INPUT : Only signals input from the 7.1CH INPUT terminal will be
	played back.

Aspect

Set the aspect ratio for the video signals output to the HDMI.

BD DVD VCR

SAT GAME z AUX1 TV z

Full : Output at 16:9 aspect ratio.

Normal : Output at 4:3 aspect ratio.

“Aspect” can be set when “i/p Scaler” is set to anything other than “OFF”.

• “HDMI” can be set for input sources for which “HDMI” is assigned at
“Input Assign” (vpage 48).
• “Digital” can be set for input sources for which “Digital” is assigned at
“Input Assign” (vpage 48).
• If the input source is set to “TV” or “Game”, it cannot be set to “Analog”.
• When digital signals	are properly input, the	indicator lights on
the display. If the	indicator does not light, check the digital input
connector assignment and the connections.
• If “HDMI Control” is set to “ON” and a TV compatible with the ARC is
connected via the HDMI MONITOR connectors, the input mode whose
input source is “TV” is fixed to ARC.

This can also be set by pressing A/D on the remote control unit.

Each time A/D is pressed, the setting is changed as shown below.

		Auto	HDMI		Digital	Analog
				7.1CH INPUT
Decode Mode	Auto : Detect type of digital input signal and decode and play automatically.
Set the decode mode for	PCM : Decode and play only PCM input signals.
input source.	DTS : Decode and play only DTS input signals.

BD

SAT

TV

DVD	VCR
GAME	AUX1
CD	SIRIUS

•This item can be set for input sources for which “HDMI” or “Digital” is assigned at “Input Assign” (vpage 48).

•Normally set this mode to “Auto”. Set “PCM” and “DTS” when inputting the corresponding input signal.

•This can also be set by pressing D.MODE on the remote control unit.

50

Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
buttons	(Up/Down/Left/Right)