Assembling Your Cordless Sweeper

Insert into Lower Handle

Before you start:

Your Cordless Sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing (pg. 2) This will help you in the assembly and operation of your cordless sweeper.

Note: The charging adapter is shipped inside the dust cup.

Lower Handle

Battery Removal & Disposal

NOTE: If uncertain as to how to remove your battery pack, we suggest you take your sweeper to a reputable small appliance service technician to have this service performed.

Follow these steps when battery removal is required.

This sweeper is equipped with Ni-Cd batteries and you need to dispose of them properly. When the batteries are no longer good for use, they must be removed from the sweeper for disposal. Do not remove the batteries for any reason other than disposal of them. The batteries must be recycled or disposed of in accordance with local regulations. Please consult your Yellow Pages or local recycling center for more information.

Fig. 1

Fig. 2

WARNING: You must never use ordinary batteries for replacement as these may leak and cause damage. Use only battery pack X9730 for replacement.

1.In the event that the edging tool is not attached to the sweeper, insert the edging tool into the "square" hole under the bottom of the sweeper power head. Gently but firmly push until the edging tool locks into place. (Fig. 1)

2.Insert the lower handle - small end - into the sweeper power head. Push until firmly in place. (Fig. 2)

3.Attach the telescoping tube to the extension tube by pushing the plastic insert into

the bottom part of the telescopic pole. (Fig. 3a) Push in until the "tab" on the

plastic insert snaps into the open slot on the telescopic tube. Push the telescoping tube

into the upper handle. (Fig. 3) Insert the extension tube into the lower handle so that the “tab” on the plastic insert snaps into the open slot on the lower handle. (Fig. 3b)

4. Place the handle into the upward	Fig. 3b
storage position.	Fig. 3a

5.Plug the charging adapter into the sweeper power head charging jack. Plug the charging adapter cord

into a standard electrical outlet (120V, 60Hz.) The red charging

indicator should illuminate or flash. IfFig. 3 it does not, depress the On/Off switch

one time.

CAUTION: ALWAYS USE ADAPTOR SUPPLIED (ONLY) WITH SWEEPER

Removal of Battery Pack

1.Remove the extention handle and dust cup container.

2.Turn unit over so that the base is facing upwards. Be careful not to turn the unit ON. (Fig. 16)

3.Push in locking tab and lift off battery assembly. (Fig. 17)

4.Place battery assembly aside.

5.Insert the new battery assembly into unit. Ensure that locking tab snaps in place.

CAUTION: This appliance contains Ni-Cd batteries. The batteries must be recycled or disposed of in accordance with local regulations. Please consult your Yellow Pages or local recycling center for more information.

Fig. 16

Fig. 17