Euro-Pro UV627 owner manual Cleaning the Dust Container, Charging the Cordless Sweeper

Page 6

CLEANING THE DUST CONTAINER

To achieve the best performance, empty the dust container after each use.

1. Pull the dust

 

3. Replace dust container on cordless

container straight

 

sweeper.

 

out from the side.

 

4. Periodically remove the brush cover on

 

the front of the cordless sweeper and

(Fig. 7)

 

 

remove any build up of lint, hair or fiber

 

 

Fig. 7

 

on the rotating brush. To remove the

2. Empty dust

 

cover - grip the cover from the bottom,

 

pull out and

 

container contents.

 

upward until the

 

(Fig. 8) If desired-

 

cover unlocks

 

you may rinse with

 

from the side

 

water to clean the

 

slots and tabs

 

dust container –

 

located on the

 

but dry thoroughly

Fig. 8

top of the

 

sweeper. (Fig. 9)

Fig. 9

before replacing on the sweeper.

 

 

 

CAUTION: Do not accidentally turn unit on while cleaning. Do not clean while unit is charging.

CHARGING THE CORDLESS SWEEPER

1a. Connect the charger plug to the charging jack or hole on the back of the sweeper. Plug the the charging adapter into the wall outlet. (120V., 60Hz.) Use only TechWorld Charger AD-1215-UL8. (Fig. 10)

OR

1b. Connect the charger plug on the charging jack of charging stand (Fig. 11). Plug the charging adapter into the wall outlet (120V., 60Hz). Use only Techworld Charger AD-1215-UL8, and place the unit in the charging stand. (Fig. 12)

2.This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must be charged for a minimum of 20 hours.

3.When recharging the unit, the "On/Off" switch must be in the "OFF" position.

4.The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.

5.When the battery is running low, the speed indicator lights will start to flash. To recharge, repeat step #1 above. Charging times will vary depending upon the amount of usage between charging cycles.

Fig. 10

Fig. 11

Fig. 12

Note: Your sweeper is highly advanced and has electronic controls that optimize the cleaning ability and durability of the sweeper. Please review the following instructions carefully to ensure that all features are utilized for best performance.

1.The electronic controls of your sweeper will prevent the batteries from being deeply discharged and will indicate this by the speed indicator lights flashing. The sweeper will then stop operating. This is normal. To start charging the unit, turn the sweeper off, plug in the adapter or the charging stand and attach the sweeper to charge.

2.When the sweeper on/off switch is depressed the sweeper will slowly come up to speed. This is done to optimize the life of all components of the sweeper and is normal.

3.When first started, the sweeper will start in the highest speed “III” to prevent overloading the unit when starting on heavy carpets. Other speeds can then be selected by depressing the speed selector switch.

4.For best cleaning performance, use speed “I” (low) on floors, speed “II” (medium) on carpets, and use speed “III” (high) for turbo deep cleaning. These are guide lines and you will find the optimum speed settings for your surfaces and debris to be picked up through use and experience.

5.The sweeper will automatically try to maintain speeds on all surfaces. The unit may appear to be pulsing during use to maintain it’s speed, this is normal. If this occurs, please select the next highest speed to gain optimum performance.

6.To protect your sweeper and it’s components, the sweeper is provided with an electronic overload circuit. If something were to jam or overload the brush bar system, the units speed indicators will flash and the unit will stop operating, this is normal. If this occurs, first turn the unit off, then remove the obstruction before turning the unit on again.

NOTE: If, when you place the sweeper to recharge and the charging indicator light does NOT illuminate, then press the On/Off button once to turn the sweeper off. The charging indicator light should now light up.

NOTE: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.

IMPORTANT: To maintain peak performance of your cordless sweeper, it is recommended that the unit be fully discharged, then completely re- charged at least once a month.

CAUTION

Use only with the battery pack supplied with the unit. (Item # XBP615)

Do not attempt to remove the battery pack from the unit to charge it.

Never attempt to throw the battery pack or unit into a fire or incinerate it.

Do not attempt to remove or damage the battery casing.

Battery must be recycled or disposed of in accordance with local regulations at the end of it's service life. Please consult your Yellow Pages or local recycling center for more information.

5

6

 

Image 6
Contents Speed Cordless Sweeper Model UV627 Volt DCONE 1 Year Limited Warranty For Household USE onlyCare and Maintenance Storing the Cordless SweeperAssembling Your Cordless Sweeper Battery Removal & DisposalRemoval of Battery Pack Before you startHOW to Operate Your Cordless Sweeper Changing the Rotating Brush, Gear Box & SqueegeeCleaning the Dust Container Charging the Cordless Sweeper

UV627 specifications

The Euro-Pro UV627 is an innovative home cleaning solution designed to enhance the efficiency of your cleaning regimen while incorporating health-conscious technology. This versatile device blends traditional cleaning methods with the latest in ultraviolet (UV) technology to ensure your living space remains sanitary and fresh.

One of the main features of the Euro-Pro UV627 is its dual cleaning capability. It combines powerful suction with the effectiveness of UV sterilization, making it suitable for a variety of surfaces, including carpets, hard floors, and upholstery. The vacuum allows for thorough dirt and dust removal while the UV light targets and neutralizes bacteria and allergens, providing an extra layer of cleaning that is particularly beneficial for households with pets or members suffering from allergies.

Another significant characteristic of the Euro-Pro UV627 is its ergonomic design. The unit is lightweight and easy to maneuver, minimizing strain during extended cleaning sessions. It also boasts a sleek profile, allowing it to reach under furniture and into tight spaces with ease. Users appreciate its user-friendly interface, which includes intuitive controls for switching between modes and adjusting suction power depending on the surface being cleaned.

In terms of filtration, the Euro-Pro UV627 is equipped with a high-efficiency particulate air (HEPA) filter. This advanced filtration system captures fine dust particles and airborne allergens, ensuring that the air in your home is as clean as the surfaces. The HEPA filter is washable and reusable, enhancing the sustainability of this device by reducing the need for disposable bags or filters.

The device also features a large-capacity dust bin, which means less frequent emptying is required, allowing for extended cleaning sessions between maintenance. With its energy-efficient motor, the Euro-Pro UV627 delivers powerful performance without excessive energy consumption, making it an eco-friendly choice for the environmentally conscious consumer.

Smart design elements, such as LED indicators for battery life and filter maintenance, are included to enhance user experience and ensure optimal performance. Overall, the Euro-Pro UV627 stands out as an all-in-one cleaning solution that not only focuses on deep cleaning but also promotes a healthier living environment through its unique UV technologies.