Emerson CF100AP00, CF100GES00, CF100DBK00 owner manual White

BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 10

	STANDARD ON-OFF WALL
	SWITCH OR OPTIONAL SW113
	WALL CONTROL	BLACK
TO	BLACK
	(HOT)	BLACK
120-
VOLT		WHITE
SUPPLY	WHITE
		WHITE
	GROUND	BLACK

TWO-CONDUCTOR

CABLE (WITH

GROUND)

GREEN WIRE (GROUND)

FROM HANGER BALL AND

HANGER BRACKET

Figure 14

BLUE WHITE

BLACK

BLUE

WHITE

HANGER BALL

3. Push the wires and connectors up into the outlet box while inserting the receiv- er fully into the hanger bracket. Position the antenna wire on top of the receiver.

4. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 13).

5. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 15).

6. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 15). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.

CEILING

COVER

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

7. Screw three 60-watt (maximum) cande- labra base bulbs into the light fitter sockets (Figure 16).

8. Place the lower glass in the lower ring assembly (Figure 16). Unscrew four bracket mounting screws from the four lower ring posts.

BRACKET MOUNTING

SCREW (4)

60-WATT CANDELABRA BASE BULB (3)

LOWER RING

BRACKET

SOCKET

LOCKWASHER

(2)

KNURLED

KNOB (2)

Figure 15

THREADED
STUD (2)	POST	LOWER RING
		ASSEMBLY
		LOWER GLASS

Figure 16

10 U.L. Model No.: CF100