Echo PE-266/S specifications Long Term Storage Over 30 Days

Page 28

STORAGE

PE-266/S

 

 

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6-7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

28

X7502026303

© 6/2014 ECHO Inc.

Image 28
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information International Symbols On / OFFPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Drive Shaft/Power Head AssemblyThrottle Linkage and Ignition Leads Assembly Support HandleOperation FuelFuel Requirements Handling FuelAfter use Starting Cold Engine Purge BulbStarting Warm Engine Stopping EngineOperation Techniques Maintenance Intervals MaintenanceSkill Levels Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenCarburetor Adjustment Exhaust Port CleaningEngine Break-In High Altitude OperationLubrication Gear HousingDrive Shaft Blade Replacement Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements ExceptionsWarranty Statements ECHO, Incorporated