PREPARATION FOR USE
WARNING
Unlock chain brake
Brake lever
(Front hand guard)
Spiked bumper
Two nuts Clutch cover
Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.
GUIDE BAR AND SAW CHAIN INSTALLATION/REMOVAL
1.Remove spark plug lead. (See page 25)
2.Remove two clutch cover nuts and remove clutch cover.
3.Remove bar and saw chain if necessary. See “Maintenance and Care” section for guide bar/ saw chain maintenance procedures.
Clutch | Guide bar studs |
Clutch cover |
|
Guide bar adjuster hole | Nuts |
|
4.Unlock the chain brake, and mount guide bar on studs and slide toward clutch to make saw chain installation easier. Install chain with cutters on top of guide bar facing foward.
5.Install the clutch cover over the guide bar studs. Ensure chain tension adjuster pin fits into the guide bar adjuster hole. Tighten clutch cover nuts finger tight.
10 |