Echo CS-352 instruction manual When the Engine is Cold, When the Engine is Warm

Page 17

Chain brake

Ignition switch

Start / Run

Choke control knob

Choke

Purge pump

Starter handle

Unlock chain brake

Chain brake

Choke control knob

Open choke

Unlock chain brake

WHEN THE ENGINE IS COLD

CAUTION

Make sure the bar and chain are free from any obstruction when starting the chain saw.

Move chain brake lever fully forward to lock chain brake before starting.

Fill the fuel tank with fuel mixture.

It is not permitted to fill fuel above the shoulder level of fuel tank.

Fill the chain oil tank with lubricant. Do not over fill.

Move ignition switch to “RUN” position.

Push purge pump 3 to 4 times or until fuel is visible in purge pump.

Pull choke control knob all the way out. (Choke position)

Securely hold the chain saw as shown and pull starter handle several times until first firing sound.

Push choke control knob all the way in.

Pull starter handle to start the engine.

When engine starts, immediately squeeze throttle trigger, to release throttle latch, and pull front hand guard towards the operator immediately. (Chain brake unlocked position)

WHEN THE ENGINE IS WARM

CAUTION

Make sure the bar and chain are free from any obstruction when starting the chain saw.

Move chain brake lever fully forward to lock chain brake before starting.

Confirm there is fuel and chain oil in the tanks.

Move ignition switch to “RUN” position.

Securely hold the chain saw as shown and pull starter handle.

Choke may be used if necessary, but after first firing sound, pull throttle trigger to release choke.

After starting the engine, pull front hand guard towards the operator immediately. (Chain brake unlocked position)

15

CS-352

Image 17
Contents Chain SAW Copyright 2010 All Rights Reserved Rules for Safe Operation Kickback Safety Precautions for Chain Saw UsersOther Safety Precautions Symbols and Signs ContentsDecals Symbol FormPacking List 890191-30131 X503-010400 Part Number Nomenclature of PartsChain tension adjuster Device to adjust chain tension Operator Safety Spark Arrestor Muffler Correct USE of Chain BrakeKick Guard to BAR Instructions Guide BAR and SAW Chain INSTALLATION/REMOVALPreparation for USE Adjusting Chain Tension Fuel Statement Fuel and LubricantEmission Control Emission DataHandling Fuel Chain Lubricant OperationWhen the Engine is Warm When the Engine is ColdStopping RunningChecking Chain Tension Chain Lubrication TestGeneral Cutting InstructionFelling the Tree Bucking LimbingChain Brake Operation Testing the BrakeWinter Operation Automatic Chain BrakeSAW Chain Chain and Guide BAR CombinationGuide BAR Skill Levels Maintenance and CareMaintenance Intervals High Altitude Operation Carburetor AdjustmentCheck Fuel System AIR FilterSpark Plug Fuel FilterMuffler Spark Arrestor SprocketCylinder Fins Setting SAW Chain Setting the SAW ChainCS-352 Problem Cause Remedy TroubleshootingStorage After USE Technical DataExceptions Warranty StatementsPurchased Repair PARTS, Short Blocks and Accessories MANUFACTURER’S Warranty Coverage
Related manuals
Manual 44 pages 54.04 Kb