Echo CS-352 instruction manual AIR Filter, Check Fuel System, Spark Plug, Fuel Filter, OIL Filter

Page 27

Cylinder cover

 

 

Air filter

Cylinder cover latch

Cylinder cover latch

 

AIR FILTER

Check before every use.

Press hand guard forward and close choke.

Release the cylinder cover latch, and remove the cylinder cover and air filter.

Brush off dust lightly, or clean with compressed air, or replace the air filter.

Reinstall air filter and the cylinder cover, engage latch.

CHECK FUEL SYSTEM

Check before every use.

After refueling, make sure fuel does not leak from around fuel pipe, fuel grommet or fuel tank cap.

In case of fuel leakage there is a danger of fire. Stop using the machine immediately and request your dealer to inspect or replace.

0.65 mm (0.026 in.)

SPARK PLUG

Check periodically.

The standard spark gap is 0.65 mm (0.026 in.).

Correct the spark gap if it is wider or narrower than the standard gap.

Fastening torque: 15 to 17 N·m (130 to 145 in. lb.).

FUEL FILTER

Fuel tank cap

Oil tank cap

Fuel filter

Check periodically.

Do not allow dust to enter fuel tank.

A clogged filter will cause difficulty in starting engine or abnormalities in engine performance.

Pull the fuel filter out through fuel inlet port with a piece of steel wire or the like.

When the filter is dirty, replace it.

When the inside of the fuel tank is dirty, rinsing the tank out with gasoline can clean it.

OIL FILTER

• Check periodically.

• Do not allow dust to enter into oil tank.

• A clogged oil filter will affect the normal

lubricating system.

• Pull it out through oil filling hole with a piece of

steel wire or the like.

Oil filter

If the filter is dirty, wash it in gasoline or replace

 

it.

When the inside of the tank gets dirty, rinsing the

 

tank out with gasoline can clean it.

25

CS-352

Image 27
Contents Chain SAW Copyright 2010 All Rights Reserved Rules for Safe Operation Kickback Safety Precautions for Chain Saw UsersOther Safety Precautions Symbols and Signs ContentsDecals Symbol FormPacking List 890191-30131 X503-010400 Part Number Nomenclature of PartsChain tension adjuster Device to adjust chain tension Operator Safety Spark Arrestor Muffler Correct USE of Chain BrakeGuide BAR and SAW Chain INSTALLATION/REMOVAL Preparation for USEKick Guard to BAR Instructions Adjusting Chain Tension Fuel Statement Fuel and LubricantEmission Data Handling FuelEmission Control Chain Lubricant OperationWhen the Engine is Warm When the Engine is ColdChain Lubrication Test RunningStopping Checking Chain TensionGeneral Cutting InstructionFelling the Tree Bucking LimbingChain Brake Operation Testing the BrakeWinter Operation Automatic Chain BrakeChain and Guide BAR Combination Guide BARSAW Chain Maintenance and Care Maintenance IntervalsSkill Levels High Altitude Operation Carburetor AdjustmentFuel Filter AIR FilterCheck Fuel System Spark PlugSprocket Cylinder FinsMuffler Spark Arrestor Setting SAW Chain Setting the SAW ChainCS-352 Problem Cause Remedy TroubleshootingStorage After USE Technical DataExceptions Warranty StatementsPurchased Repair PARTS, Short Blocks and Accessories MANUFACTURER’S Warranty Coverage
Related manuals
Manual 44 pages 54.04 Kb