Power PrunerTM Attachment | 7 |
Operator's Manual |
equipment
Before operation a complete check of the unit must be performed;
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
•ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
•DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
•NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
Description
Locate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow the instructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING
instructions for specific information.
1
9
P/N X505001821
1.GRIP, FRONT - Cushioned grip for left hand.
2.SHAFT DECAL - Contain important safety information that must be followed.
3.LOWER DRIVE SHAFT ASSEMBLY - Contains a specially designed liner and the flexible drive shaft.
4.CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.
5.AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
6.SAW CHAIN - 91 VX 9.53mm (3/8 inch) low profile Oregon® saw chain. Runs approximately 725 m/min.
(2378 ft/min) at 6500 RPM.
7.GUIDE BAR - 254 mm (10 inch) Bar
8.CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerate and lower saw chain into branch.
9.GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar cover before using unit.