Power PrunerTM Attachment | 9 |
Operator's Manual |
5.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.
6.Secure lower shaft assembly to coupler by tightening clamping knob (D).
front loop handle removal
Tools Required: Screwdriver.
Parts Required: None
NOTE
Front loop handles/loop handles with barrier bars are not recom- mended for use with Power Pruner attachment.
1.Remove front handle assembly, barrier bar (if installed), and mount- ing hardware from PAS or
2.Retain parts for future use.
saw chain tension adjustment
Tools Required: 10 mm Wrench, Screwdriver
WARNING
Always wear gloves when handling saw chain, otherwise serious personal injury may result.
To Adjust Saw Chain Tension.
1.Loosen two (2) guide bar nuts (A) located on cutting attachment.
2.Turn saw chain tensioner screw (B) clockwise to tighten saw chain on guide bar. Turning screw counter clockwise will loosen saw chain on guide bar.
3.Tighten guide bar nuts firmly. Move saw chain backwards on guide bar by hand. Saw chain should move freely on guide bar if it is
in proper mesh with sprocket. If saw chain is difficult to rotate or binds on guide bar, it is too tight.
Keep the saw chain lubricated and properly adjusted and the guide bar nuts tightened firmly at all times.
B
A