CARE AND MAINTENANCE
STEERING CONTROL ADJUSTMENTS (continued):
To adjust neutral springs:
1.Loosen set screws on center spring stop collar located on the control rods. (Requires a 1/8” Allen wrench).
2.Swing control lever out. Tighten set screw on lock collar.
3.Repeat for opposite side.
4.Engage parking brake and lower seat frame.
Release parking brake and swing control levers in. If wheel creeps, repeat steps 1 and 2.
5.Stop engine and remove rear of machine from jack or blocks.
6.Return the seat to the operating position.
7.Drive machine with both levers in top speed position. If one side now drives slightly faster than the other adjust forward speed bolt in to contact stop sooner.
If levers are now uneven at top speed, loosen control lever mounting nut. Rotate lever to be even with other side and tighten nut.
47