Dixon 18626-106 manual Changing the Engine OIL

CARE AND MAINTENANCE

CAUTION HOT oil may cause burns. Allow engine to cool before draining oil.

CHANGING THE ENGINE OIL:

1.The “Dapco” oil drain valve is located on either side of the engine crankcase (depending on the type of engine installed on your ZTR®).

2.Place a suitable container under the drain valve hose.

3.To drain, turn hex head valve stem counter-clockwise with a 10mm wrench or socket. Open to full open (approximately 7 turns).

4.After engine is drained, tighten hex stem.

5.Change oil filter.

6.Fill with oil (see steps on next page).

NOTE: Refer to engine manufacturer’s recommenda- tions for frequency of oil changes.

Hex Head Valve

Stem

38