Dixon D26KH54 manual To Check Brake, Front Wheel TOE-IN/CAMBER, To Remove Wheel See Fig

Page 24

SERVICE AND ADJUSTMENTS

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL (See Fig. 39)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 39

TO START ENGINE WITH A WEAK BATTERY (See Fig. 40)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

Fig. 40

REPLACING BATTERY (See Fig. 41)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift hood to raised position.

Remove terminal cover.

Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

Reinstall terminal cover.

First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

Close hood.

24

Image 24
Contents D26KH54 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Keys Slope SheetAssembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidChecklist Operation Know Your Tractor Reverse Operation System ROS onHOW to USE Your Tractor To Adjust Mower Cutting Height See Figs To Adjust Gauge Wheels See FigSystem Characteristics To USE Cruise Control J See FigTo Stop Mower Blades Reverse Operation System ROSTo Operate on Hills To Transport See FigService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower and Drive Belt See FigsTo Remove Mower See Fig SET Parking Brake Lever and Lower AT- Tachment Lift See FigANTI-SWAY BAR S Turn Steering Wheel Left and Position Mower See FigSlide Mower Under Tractor See Fig Install Belt on Engine Clutch Pulley M See Attach Mower Side Suspension Arms a to Chassis See FigAttach Rear Lift Links C See Fig Attach Front Link E See FigTo Level Mower To Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXService Notes Service Notes Limited Warranty

D26KH54 specifications

The Dixon D26KH54 is a remarkable lawn and garden equipment model that stands out due to its powerful features, cutting-edge technologies, and robust characteristics. Designed with efficiency and ease of use in mind, this machine is an ideal choice for both residential and commercial landscaping needs.

One of the standout features of the D26KH54 is its engine. Powered by a reliable and efficient Kohler engine, this model ensures consistent performance and impressive power output. With its ability to handle various conditions, the engine allows users to tackle even the toughest mowing jobs with confidence. The engine's efficiency translates to lower fuel consumption, making it an environmentally friendly option for users.

Another noteworthy characteristic of the Dixon D26KH54 is its cutting deck. Featuring a wide 54-inch cutting width, the deck allows for rapid mowing, significantly reducing the time needed to cover large areas. The deck is also equipped with multiple height adjustment settings, enabling users to customize the cut according to their specific lawn care requirements. This flexibility ensures a clean and professional-looking finish every time.

The D26KH54 incorporates advanced technologies that enhance user comfort and efficiency. Ergonomically designed controls provide an intuitive interface, making it easy for users to operate the mower even during extended periods. The seat is well-padded and adjustable, which adds to the comfort factor while minimizing fatigue during prolonged use.

Durability is another key aspect of the Dixon D26KH54. Constructed from high-quality materials, this mower is built to withstand the rigors of outdoor use. The heavy-duty chassis and reinforced frame provide stability and longevity, ensuring that the machine can handle challenging terrains without compromising performance.

Additionally, the D26KH54 offers exceptional maneuverability, thanks to its responsive steering and compact design. It is capable of navigating around obstacles with ease, making it an ideal choice for residential lawns with intricate landscaping.

Lastly, the maintenance of the Dixon D26KH54 is straightforward, with easily accessible components designed for quick servicing. Users can perform routine checks and necessary repairs without hassle, further enhancing the overall experience of owning this model.

Overall, the Dixon D26KH54 is a powerful, efficient, and user-friendly mower that embodies the perfect blend of technology and ruggedness, making lawn care an enjoyable task for every user.