Assembly, 1INSTALL Plate and Hanger | Dixon 966004101 specification

ASSEMBLY

1INSTALL PLATE AND HANGER

1.Using hardware provided in kit, attach support mount to unit.

2.Attach hanger bracket to support mount. Do not fully tighten nuts at this time.

Support Mount

Hanger Bracket

3.Secure rear end of support straps to outside of hanger assembly. Set reinforcement plates to the outside of the tank brackets and fasten front end of support strap to tank bracket and reinforcment plate with round head bolt. Secure front end

of reinforcement plate to tank bracket with hex bolt. Fully secure all mounting hardware. See illustration.

NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large.

Hex Bolt Placement

Round Head

Bolt Placement

2MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY

For ease of assembly, you may wish assistance from another person for mounting the cover assembly to mower.

1.Position cover assembly on the ground behind the mower.

2.Lift and rotate cover to align the frame bracket with the hanger and slide the cover down until secure.

Cover Assembly

Frame

Bracket

Hanger

3 INSTALLING SPACER PLUG Remove plastic end cap from the center bag support arm. Fully insert spacer plugs into the ends of the support tube. It may be necessary to tap the spacer into place with a hammer or mallet. Replace the plastic end cap back over the spacer. The additional extension will hold the hood more securely when latched.

Reinforcement Plate	Remove center	Insert spacer and
		replace cap
	end cap

Support Straps