Dixon 503 Operation Instructions, Throttle Control Lever, Blade Drive, Light Switch, Fuse Block

Page 16

Page 13

OPERATION INSTRUCTIONS (continued)

THROTTLE CONTROL LEVER:

Controls engine speed, has positive detent in fully opened position to insure adequate cooling of the engine and maintain mower deck blade speed in a mowing application. Throttle will automatically return to idle position if not locked into the positive detent located on control panel to operator's right.

MOWER DECK CUT HEIGHT LIFT LEVER:

Controls the cutting height of the mower deck. Seven positions of adjustment in which the very top, or highest notch, is used for transporting the mower in a non- mowing situation. Located in front of operator on the right side of mower.

BLADE DRIVE:

To engage the mower deck cutter blades, lift switch up lightly and push forward. To disengage blades, pull switch backward. Switch is clearly marked "on and off".

LIGHT SWITCH:

The headlights are activated by pushing the switch forward. Failure to turn off the lights, once the engine is stopped, will result in rapid discharge of the battery.

FUSE BLOCK:

Protection of the electrical system is by (1) 15 AMP fuse. To remove the fuse for inspection, just simply lift upon fuse block lid. If fuse burns quickly, please consult your dealer for inspection and repair. Never attempt to bypass the fuse by any method.

Image 16
Contents Page FAX 316 251 Specifications Operation InstructionsSafety Never run the mower blades when there are people nearbyThis product Safety Safety Reminders Read Carefully Before Operation Safety Reminders Page Chassis 11 GA rectangular tube Dimensions Width Height Length Weight 630 IbsBlade Drive Warner electric clutch Deck leveling procedure Final preparation SET UP and ServiceSeat Assembly Instructions Upper Control Lever Installation Repeat above procedure on left sideRaise rear body cover to fully open position Mower Deck Installation Position mower deck under chassisLeveling Principals Remove battery from chassis Final PreparationSound judgment by the owner will prevent accidents No shifting or clutching requiredLight Switch Operation InstructionsThrottle Control Lever Blade DriveCare and Maintenance Model Maintenance ScheduleCutter Blade Removal Reverse procedure to re-install deck assemblyBelt Tension Forward Lever Stop Adjustment Each front wheel caster Number of grease zerks usedEngine manufacturer Care and Maintenance Model Cleaning the Mower Poor cut quality CutManual MaximumDrive adjustment Or the otherRepair Box belts slippingTrouble Shooting Cause Remedy SituationPage Box, Gearbox & Hydrostats Assembly Model ZTR Fuel & Hydraulics Tanks & Fittings Assembly Model ZTR Mower Deck Assembly Model ZTR Chassis Assembly Model ZTR Body Assembly Model Zl R 5O3 1471 Seat Slide Seat StrapGrease Zerk 5625 Gearbox 6113 Blade Washer8177 Caster Tire 8178 Caster Rim 8179 8180