Dixon 8000G Series Mower Blade Switch, Ignition Switch, Choke Control Lever, Circuit Breaker

CONTROLS

MOWER BLADE SWITCH:

To engage blades: pull up on switch

To disengage blades: push down

IGNITION SWITCH:

•Turn to start position to crank engine. Release when it starts.

•For headlights - rotate switch one notch counter-clockwise from run.

Note: Remove key when mower is not in use.

CHOKE CONTROL LEVER:

•Located on the control panel to the operator’s right.

THROTTLE CONTROL LEVER:

•Located on control panel to operator’s right.

•Controls engine speed.

•While mowing, throttle control should be set to MAXIMUM or wide open setting to insure adequate cooling of the engine and to maintain mower deck blade speed.

CIRCUIT BREAKER:

•If circuit breaker pops up, it disconnects the power. Wait 2 minutes and push to reset.

•If it pops up again, there is a short circuit. Stop and find fault or contact your dealer.

17