Dixon 966494901 manual Risk of sparking

Page 15

SAFETY

Sparking can occur when working with the battery and the heavy cables of the starter circuit. This can cause battery explosion, fire or eye injury. Sparking in this circuit can not occur after the chassis cable (normally negative, black) is removed from the battery.

Use protective goggles.

Ensure that the fuel filler cap is mounted tightly and no flammable substances are stored in an open vessel.

WARNING!

Avoid electrical sparking and its consequences by the following routines:

Never work with the starter circuit if there is spilled fuel.

Disconnect the negative cable from the battery first and reconnect it last.

Do not make a bridge short circuit across the starter relay to run the starter.

Never use the machine indoors or in spaces lacking proper ventilation. The exhaust fumes contain carbon monoxide, an odorless, poisonous, and lethal gas.

Stop to inspect the equipment if the machine runs over or into anything. If necessary, make repairs before starting.

Never make adjustments with the engine running.

The machine is tested and approved only with the equipment originally provided or recommended by the manufacturer. Only use approved repair parts for the machine.

The blades are sharp and can cause cuts and gashes. Wrap the blades or use protective gloves when handling them.

Check the parking brake’s functionality regularly. Adjust and service as necessary.

The mulch blades should only be used in familiar areas when higher quality mowing is desired.

Reduce the risk of fire by removing grass, leaves, and other debris that may have accumulated on the machine.

Allow the machine to cool before putting it in storage.

Regularly clean deck and underside of deck, avoid spraying engine and electrical components with water.

6003-009

Do not smoke when performing maintenance on the battery. The battery can explode and cause serious injury/damage.

8009-728

Risk of sparking

8011-514

Regularly clean deck

15

Image 15
Contents Operator Manual Page Contents Page Introduction Manufacturing Number Good ServiceSymbols and decals Remove key before Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Ignition Switch Parking BrakeThrottle Control Refueling Choke ControlAlways use the high position F to transport Fuel Shut Off ValveMower Deck Lifting Lever TrackingManual Transport Blade Control LeverSteering TrainingStarting the Engine Before StartingPlace controls in neutral position Open the fuel valve To remove cables, reverse order Jumper cablesRunning Operating on Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MaintenanceEvery 50 hours Battery To clean battery and terminalsAlways use protective glasses when handling the battery Tire Pressures Safety SystemBelts Deck BeltTo replace deck belt Cutting Blades EZT BeltLeveling Deck Adjusting the Mower DeckCaster Wheels CleaningRemoval and installation of caster wheel Use protective glasses when cleaning and washingGeneral LubricationSteering Control Shafts Front Wheel MountFront Wheel Bearings Engine LubricationProblem Cause TroubleshootingTroubleshooting Winter Storage ServiceSchematic Technical Data Torque SpecificationsStandard Hardware SpeedZTR EngineTransmission Overall dimensions EquipmentProductivity CE requirements USA requirementsService Journal Delivery ServiceAction Date, mtr reading, stamp, sign After the First 10 Hours Hour ServiceService Journal At Least Once Each Year Page 115 161126R1 11/24/09