Dixon 17823-0704 manual Mower Deck Leveling Procedure

Page 46

CARE AND MAINTENANCE

MOWER DECK LEVELING PROCEDURE:

1.Place mower on a smooth, level surface and check tire pressures to insure correct stance. Tires should be inflated as follows.

Front: 16 - 21 lbs

Rear: 8 - 14 lbs

2.Turn each outer blade tip to align with the deck in a side to side manner.

3.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower. Retain this measurement. Move to the opposite side and check to see if that measurement is the same. If adjustment is required, turn nut on one or both of the front L-rods until both measurements are equal.

4.Turn each outer blade tip to align with the deck in a front to rear manner.

5.Measure from the floor surface up to the bottom of the blade tips at both the front and rear of the blades. Rear of blade tips should be 1/8" to 1/4" higher than the front of blade tips. If adjustment is necessary, loosen jam nuts on tie bar. Rotate bar to achieve desired height. Retighten jam nuts.

(See Illustration B, page 45)

NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions involved.

46

Image 46
Contents RAM Series Important Read Carefully Table of Contents Safety Safety Alert Symbol General Operation General Operation General Operation Slope Operation Slope Operation Do not Fire Hazards Fire Hazards Children Service Dixon ZTR Residential Warranty Policy RAM 44 MAG and RAM 50 MAG~Commercial Mowers Specifications Residential ModelsCommercial Models Models Seat Adjustment Instructions50 Models Controls Control LeversTo SET Parking Brake Parking BrakeTransmission Drive System Circuit Breaker Blade DriveThrottle Control Lever Mower Deck CUT Height Lift Lever Operation Instructions Before Operating MowerStarting Instructions Towing Trailers and Other Attachments To Free Wheel Machine Unlock TransmissionTesting of Safety Interlock Systems Parking Brake Switch TestEngine should Stop Mowing with a Mulching Attachment Mowing with a Mulching Attachment Mowing with a Grass Catcher Attachment Mowing with a Grass Catcher Attachment Failure to observe the following instructionsSide Discharge of the Clippings Grass Height & Cutting Suggestions Care and Maintenance Maintenance ScheduleCutter Blade Maintenance Battery EngineTires LubricationBelts Belt TensionBelt Tension Manual Adjustment Changing the Engine OIL OIL Fill Neutral Adjustment Illustration a Illustration B Mower Deck Leveling Procedure PARTS/SERVICE Cleaning the MowerWarranty Electrical SystemsDeck Removal Standard Service Parts List BladesEngine AIR and OIL Filters Troubleshooting Engine WON’T Turn OverMower Loses Power or Transmission Overheats Page Page OWNER’S Information Date OIL Changed Date Engine TunedRAM Series