3BAGGER Support Assembly, 5CONTAINER Mounting

ASSEMBLY

3BAGGER SUPPORT ASSEMBLY

1.Attach bagger support to engine guard using four 3/8 -16 x ¾ bolts and four 3/8 -16 nyloc nuts.

2.Using bagger support as a template, drill two 11/32 holes through the engine guard toward the bottom. (See illustration)

3.Attach hanger bracket to bagger support with four 5/16 -18 x 1 carriage bolts and four 5/16 nyloc nuts. (See illustration)

4.Remove top side bolts on the engine guard. Attach support straps and engine guard to frame using two 5/16 -18 x 1 carriage bolts and two

5/16 -18 nyloc nuts.(See illustration) Make sure support strap tabs are facing toward the rear. Attach tab end of support straps to bagger support using two 5/16-18 x 1 bolts and two 5/16 -18 nyloc nuts.

Hanger Bracket

Support Strap Tab

Bagger Support

Engine Guard

Support Strap

Drill Two 11/32 holes into engine guard to match these holes

WARNING

DO NOT operate mower unless container is properly installed. Container is subject to wear and deterioration, check containers frequently, replace when cracked or damaged. Use only a recommended replacement container.

4MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY

NOTE: For ease of assembly, you may wish assis- tance from another person for mounting the cover assembly to mower.

1.Position cover assembly on ground behind mower.

2.Lift and rotate cover to align the cover bracket with hanger bracket and slide the cover down until secure.

Frame Bracket

Hanger

Bracket

5CONTAINER MOUNTING

1.Install container, centering between support tubes.

NOTE: One container should always overlap the other container at supports.

2.Close cover and lock latch handles over center support tubes.

Cover Latch

Handle

Container

Bags

Support

Tubes